Jenn-Air Wall Oven Sensors

Videos!

Your Price

$34.82

Jenn-Air Wall Oven Long Oven Sensor

★★★★★

33 Reviews

PartSelect Number PS1570174

Manufacturer Part Number 12001656

This long oven sensor is also commonly known as a temperature sensor. It is designed for use with ovens and ranges. It is similar to a thermostat; it measures and regulates the internal temperature of your oven cavity. There is an adapter at one end, a probe at the other, and they are connected by an insulated wire. The probe is approximately 7 inches long. You can test the sensor with a multi-meter for functionality. You need to check the model-specific manual to determine what the proper resistance is for your specific appliance. This oven sensor comes with two wire harness adapters and a set of instructions.

Fixes these symptoms

Door won’t open after self cleaning cycle
Element will not heat
Little to no heat when baking
See more...

Installation Instructions

David from Westford, MA

Oven not holding 350 F, when cooling the coils did not reheat

Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. The oven works fine! Note that due to thermal lag the temperature overshoots to 370 degrees and undershoots to 340 degrees, this appears to be normal oven operation. Putting door back in place was easy. Read more...

Videos!

Your Price

$46.42

Jenn-Air Wall Oven Short Oven Sensor Kit

★★★★★

26 Reviews

PartSelect Number PS2003225

Manufacturer Part Number 12001655

The temperature sensor on your oven detects the temperature within the oven cavity. If you notice your oven is too hot, not hot enough, or does not heat evenly, the short oven sensor kit may need replacing. This oven sensor is referred to as the short sensor and is 3 inches long. It should not be confused with the 6-inch-long sensor. The oven sensor is located on the back wall of the interior of the oven. Before starting this repair, be sure to disconnect the power source from the oven. If you are repairing a gas range, make sure to disconnect the gas source as well.

Fixes these symptoms

Element will not heat
Gas igniter glows, but will not light
Little to no heat when baking
See more...

Installation Instructions

george from birmingham, AL

F1 code - gas over would not heat.

Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was very easy. I removed the back panels 6 screws to gain access to the sensor's connection. I then removed the 2 screw that hold the sensor in place inside the oven and pulled the old sensor out through the oven. I reversed this process to place the new sensor in the oven. Read more...

Videos!

Your Price

$93.01

Jenn-Air Wall Oven Temperature Probe

★★★★★

3 Reviews

PartSelect Number PS11747165

Manufacturer Part Number WP9755542

Also known as a meat probe.

Fixes these symptoms

Will not program
Will Not Start
See more...

Installation Instructions

Kent from Seattle, WA

faulty meat probe

Not a repair. Just needed to replace the meat probe sensor for the programmable oven. Quick and easy purchase and very fast delivery took care of the problem. I was back in business. Read more...

Your Price

$152.39

Jenn-Air Wall Oven Oven Sensor

PartSelect Number PS11744233

Manufacturer Part Number WP74008369

This sensor detects the temperature within the oven cavity.

Fixes these symptoms

Little to no heat when baking
Oven not heating evenly
See more...

Installation Instructions

Alan from Wallkill, NY

oven temp wrong

Remove the oven door. Remove 3 self tappers on rear wall of oven to take off a round access panel. Pull out a pre-cut rectangle of insulation. Next I removed the 2 screws holding the sensor in place. Pulling the sensor out a bit told me I was "touching" the correct wires in the SMALL rectangular opening. The wires are not visable and 2 hands do not fit in this small opening.I looked at the NEW sensor to see the release on the sensor plug. Slip the angled needle nose into the opening and grasp the plug/release side. The plug pulled apart easily. The sensor wire pulls out with a little bit of twisting to fit it out the hole. The new plug pushes in and has to be worked down to where you can reach it. The same angled plier works to re-attach it. It takes longer to read this than to do the job. Best of luck, Al Read more...

Your Price

$129.22

Jenn-Air Wall Oven SENSOR

PartSelect Number PS11731446

Manufacturer Part Number W10859573

Your Price

$166.86

Jenn-Air Wall Oven Temperature Probe

PartSelect Number PS11743863

Manufacturer Part Number WP71001870

This temperature probe consists of two ends joined together by an insulated wire. The small end is almost four inches long, whereas the longer end is almost seven inches long. The small end, the jack, plugs into the range, while the longer end, the probe, is inserted into the meat. This brown and metallic temperature probe is intended for use with some ranges and some older convection microwave ovens.

Installation Instructions

Nicholas W J from Worthington, OH

temperature probe insulation broken down so short circuit

As the probe is a plug-in item that would normally be out of the oven, there was nothing more to the repair than checking that the new probe plug fitted the socket and that it was detected by the oven. Then the old probe was consigned to the trash.

Everything checked out, and the probe was used satisfactorily within a couple of days. Read more...