Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
This touch-up paint can be used on a wide variety of household appliances. It is most often used on washers, dryer, refrigerators, dishwashers, ranges, freezers, trash compactors, or microwaves. It is...
Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to...
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.
First, I unplugged the dryer. The Power button itself can be removed by grasping it in your fingers and pulling strait forward. There is also a rubber gasket between the button and switch, so hang onto that. To access the area behind the power button I needed to remove the top of the dryer. It is held in place by two torx screws on e
... Read moreither side at the back. Luckily I have a stubby screwdriver with interchangeable heads which includes two torx drivers. I used the T15 size and it worked, although I couldn't say if that is the exact size of the screw head. After removing the dryer top, I could see that behind the three push buttons (Power, Temperature, Start) are the respective Switches. Checking the schematic on Parts Select, I ordered the Power Switch. When I got it, I swapped out the old for the new one. There are four blade type connections which I did one at a time so as to get it hooked up the right way. Then guide the switch into the hole on the front panel and push the gasket and button onto it from the front. Replace the top temporarily and plug the cord back in to test it. It works! Then I replaced the torx screws to tighten down the top. The 'bit of difficulty' I had was in accessing the screws at the back as this is a compact, stackable washer and dryer which is located in a closet.
