Kenmore Wall Oven Motors

Your Price

$168.00

Kenmore Wall Oven MOTOR-CONVECTION

★★★★★

1 Review

PartSelect Number PS1993372

Manufacturer Part Number 5304463302

Your Price

$160.48

Kenmore Wall Oven Convection Fan Motor

PartSelect Number PS2349811

Manufacturer Part Number 5304467898

This motor includeds the bracket and the fan retainer nut. Fan blade is sold separately.

Installation Instructions

Willis from Friendsville, TN

Convection fan making noise

Removed old fan and replaced with new fan. To replace fan, the over interior fan blade was removed, then the two slip on wires were removed from the old fan motor, then the three screws securing the old fan motor were removed. The process was reversed to install replacement fan Read more...

Your Price

$106.74

Kenmore Wall Oven Convection Fan Motor - 240V 60Hz

★★★★★

1 Review

PartSelect Number PS466378

Manufacturer Part Number 5303311202

Your Price

$161.97

Kenmore Wall Oven MOTOR

PartSelect Number PS8692143

Manufacturer Part Number 318575612

Your Price

$139.60

Kenmore Wall Oven Cooling Fan Motor

★★★★★

1 Review

PartSelect Number PS3409398

Manufacturer Part Number 318575603

Your Price

$171.11

Kenmore Wall Oven Cooling Fan Motor

PartSelect Number PS2582194

Manufacturer Part Number 318575600

Your Price

$166.60

Kenmore Wall Oven MOTOR

PartSelect Number PS8691902

Manufacturer Part Number 139008500

Your Price

$129.71

Kenmore Wall Oven MOTOR

PartSelect Number PS3419699

Manufacturer Part Number 318398203

Your Price

$164.92

Kenmore Wall Oven Upper Cooling Fan Motor with Blade

★★★★★

2 Reviews

PartSelect Number PS237580

Manufacturer Part Number WB26K5061

Installation Instructions

David from Richardson, TX

Replace failed fan in control box

After turning off the breaker to cut power to the oven, I opened the oven door and, using the PartSelect exploded diagram as a guide, I removed 3 screws from the underside of the control panel - I was then able to slide the panel up and out to remove it. Leaving all of the control wires (especially the ribbon) connected to control panel, I saw the fan assembly mounted to the rear of the control box.

I noted the position of the two attached wires - black on top (or left), white on bottom (or right). Using a nutdriver with an extension bar, I unscrewed 4 screws holding the assembly in place. I removed the old fan and installed the new fan in its place. It was necessary to bend the new fan's legs out a bit to get them to line up with the holes. I reconnected the wires as mentioned above, then reinstalled the control panel.

I tested the oven by turning the breaker back on and letting the oven heat up to 450 degrees. The fan turned on as expected. After the oven cooled off, I reinstalled the 3 screws to secure the control panel. Read more...