Whirlpool Washer Filters

Your Price

$11.52

Whirlpool Washer Charcoal Filter

★★★★★

31 Reviews

PartSelect Number PS1871363

Manufacturer Part Number 8206230A

This Charcoal Filter traps grease from your oven's exhaust to help prevent it from entering the vent, which could cause damage over time. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually. We recommend the use of gloves during installation to protect your hands from messy grease during your repair. You should also unplug your appliance at the electrical outlet or switch it off at the breaker. Using a Phillips screwdriver, unthread the screws securing the grill. Open the door and slide the grill to the left and lift it up to remove it. This will allow access to the filter so it can be either replaced or cleaned. Remember to insert the tabs of the grill into the frame and slide it to the right when you are done. To finish, shut the oven door and secure the grill with the screws.

Fixes these symptoms

Exhaust fan not working
No heat
Noisy
See more...

Installation Instructions

Richard from San Antonio, TX

Mounting brackets are fragile and plastic support is easily broken

Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation. Read more...

Your Price

$13.60

Whirlpool Washer Screen

★★★★★

1 Review

PartSelect Number PS11746894

Manufacturer Part Number WP96160

Found on the water inlet valve.

Installation Instructions

Peter from Aurora, IL

The fill cycles would start then stop suddenly

This was an easy repair.
1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...

Your Price

$22.88

Whirlpool Washer Inner Tub Filter Plug Kit

PartSelect Number PS334684

Manufacturer Part Number 285868

Kit contains 4 plugs - replaces the lint filter that goes under spin basket. The filter under the spin basket is no longer required. Replaces round filter assembly.

Fixes these symptoms

Marks left on clothes
See more...

Installation Instructions

Bob from East Palestine, OH

The motor turned with loud noise ,but nothing else worked

I used "Emley's Cheap and Easy Repair" book to remove,install and reassemble the machine.
A lot of time was used to clean the filthy tub and basket.
While replacing the broken motor coupling I decided to replace some of the seals.
PartSelect got the ordered parts to me in a couple of days.
I wouldn't hesitate to do the job again. Read more...

Your Price

$102.73

Whirlpool Washer Agitator Lint Filter

★★★★★

2 Reviews

PartSelect Number PS11743344

Manufacturer Part Number WP63840

This lint filter sits on top of your washer's agitator. Not only does it filter the lint out of your washing machine, but it also helps the agitator to move clothing around on the inside of your washing machine.

Fixes these symptoms

Will not agitate
See more...

Installation Instructions

Virginia from Philadelphia, PA

The old lint filter was worn, and would "pop up" so that clothes weren't being moved about during the wash and rinse cycles. If I didn't frequently push it down again, it would fly off during a spin cycle. Dangerous!

I simply lifted the lint filter and its cap off, pressed the new agitator cap onto the new lint filter and put the assemblage into place. No tools needed at all. A $50 dollar repair saved me from replacing my washer/dryer! I'm very pleased. Read more...

Your Price

$119.97

Whirlpool Washer Lint Filter and Upper Agitator

★★★★★

6 Reviews

PartSelect Number PS11743343

Manufacturer Part Number WP63753

This part serves two functions for your washing machine: lint filter and upper agitator.

Fixes these symptoms

Will not agitate
See more...

Installation Instructions

Patty from Caldwell, ID

Dishwasher leaving food residue on all dishes

Had to take apart dishwasher and replace chopper assembly. The dishwasher had a lot of debris in in including pieces of broken plastic forks. Now works great Read more...