YMED6400TQ0 Maytag Dryer - Instructions

Remove the back panel, then remove the housing around the blower, just slide the housing of to the side, you don't have to take it completly of the machine. Remove the top, and remove the front until you can get to the blower motor. Cut the blower wheel plastic down to the metal nut with a fine blade in a recipricating saw, used a bi-directional broken stud remover socket on the nut that was at the center of the blower wheel and large slip joint plyer on the other end of the shaft. Replace the wheel and put back together. It took about as much time to gather up the tools as it did to fix it.,

Unplugged dryer and moved away from wall about 0ne foot. Removed lint catcher. Removed two screws holding lint catcher duct to top of dryer. Removed top of dryer by inserting putty knife into gap between top and front cover of dryer at both front corners, beginning with left side first. A slight amount of pressure and a little bit of wiggling helped to release the clip holding the dryer top on. Leaned top back and secured with a stick. Removed two screws on inside of front cover near top. Pulled up on front cover to remove. (Leave dryer door closed during this process). Removed front cover and set aside. Layed on floor and looked at Tensioner/idler pulley and made a drawing of the belt configuration at the pulley. Pulled pulley back to remove tension and removed belt from pulley. Used socket and ratchet to remove bolt holding tensioner/idler. Installed new tensioner/idler and reinstalled belt. reassembled dryer and tested.

Took my channle locks and pulled old catch out and snapped in new catch. Works great now. Cost me four dollars and 3 minutes of my time.

replaced door catch with part ordered from this website VERY EASY!! Thanks!!

We only had to tilt the dryer enough to be able to screw the leveling leg in place.The only hard part was holding the dryer steady to screw in the leveling foot.

Removed door catch and installed new one. Easy as pie, after watching installation video.

soooooooo proud of myself!!!! cause I correctly ordered and correctly installed seal on door on clothes dryer

When the part came in it was really simply. All I had to do was push the new catch into the hole and make sure it was in all the way and secure. A repair man would have charged at least $65 and it took me all of 1 minute to do.

It was simple. Originally, (just like a man) I took the door apart and removed from behind. THEN I WATCHED THE REPAIR VIDEO!!! Boy did I feel like a dummy. The repair was simple and easy. Putty knife popped the latch out and popped a new one in. Got a couple of extras for future issues. Both latches had failed previously, oddly, only 1 is actually used. Oh well, repair done, bride happy, all is well. Thanks Parts Select. Moral of the story, WATCH THE REPAIR VIDEO FIRST!!!!!!!!

repaired the door catch in 5 mins

'Twas a "SNAP" - Juss pull the ole wun owt wiff small nose plars, poosh in tha knew wun 'til she "Snaps". Close door an dry clothes

getting the machine apart was the hardest part. Replaced idler pully assembly and belt. Even with my arthritis it was easy.

My husband changed the part but part select was very helpful. With their free repair help site it made repairing a breeze! We will use parts select again and again. I did order all the parts we might have needed and only needed one. Now I will return the others.

Took the back dryer cover off and removed the lint cover all from the back of the dryer then replaces the Thermistor (held with 2 screws).

I replace the terminal block, wires , and dryer plug I unscrewed the back of the dryer and basically replace was burnt out. I was about to pay 200.00 to have it done but I looked on youtube and seen how easy it was so I just chose the site to order what I needed to be replace and it arrived quickly and more affordable to do it myself. Thanks I hope the was useful.