SE1000 Maytag - Parts

Blower Wheel Clamp

★★★★★

★★★★★

(3)

This blower wheel clamp, used in a clothes dryer, is a clamp that holds the blower wheel to the motor shaft. This part helps hold the blower wheel in place to function easily and properly. If your clo... Add to cart

Drain Pump

★★★★★

★★★★★

(18)

This washing machine drain pump is intended for use with automatic washers that have been manufactured since 1958. The pump itself is made of plastic, though it does come with a metallic belt pulley. Add to cart

Rubber Foot Pad

★★★★★

★★★★★

(1)

The leveling leg pad or foot pad fits over the leveling leg on your washing machine. The foot pad is designed to protect your floor and keep the washing machine level and in place. This foot pad is ju... Add to cart

Idler Shaft Retaining Ring This idler shaft retaining ring is well under an inch long and is made of metal. Add to cart

Tub Bearing Kit

★★★★★

★★★★★

(1)

This kit is used on 2-belt washers. It is recommended to change the seal kit at the same time. The tub bearing kit fixes issues with leaking, loud noise, excessive shaking/moving or if your pump is no... Add to cart

Syphon Break Elbow Kit with Clamp

★★★★★

★★★★★

(7)

For drain hose 7/8". Add to cart

Roller Shaft Hex Nut This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers. Add to cart

Adjustable Leveling Leg

★★★★★

★★★★★

(1)

If your washer shakes or vibrates loudly when it reaches its max speed, make sure the 4 levelling legs are even. Adjust the legs so that the machine is level, and tighten the locking nuts on the legs ... Add to cart

Spring Retaining Clip

★★★★★

★★★★★

(3)

This spring retaining clip is just under 1 inch long. The clip is made entirely of metal and is attached to the back wall of the washer, under the console. If your washer is vibrating and louder than ... Add to cart

Siphon Break Connector Kit

★★★★★

★★★★★

(14)

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines. Add to cart

Idler Arm Screw Sleeve

★★★★★

★★★★★

(3)

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer. Add to cart

High Limit Thermostat

★★★★★

★★★★★

(4)

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu... Add to cart