Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bake element cracked
I followed instructions on the partselect website. I've never fixed any appliance before, but the directions were very simple and the oven was running again in less than ten minutes.
used the pliers to remove the screws, gently pulled back the element exposed the wires gently pulled the clamps of the element, removed the element. put the clamps back on the new element, put the element back in the holes and put the screws back in.
While cleaning the oven of some excess burned on food, I inadvertently broke the inside glass in the door
Removed door from unit (easy) and separated the inside of the door from the outside and replaced the broken glass with the new replaceable glass. Took the time to also clean in between the two glasses. Looks great!
Ordered the element from partselect. got the part fast. 2 days. removed the old element 2 screw and 2 wires.installed new one in reverse order. total of 10 minutes and oven is working like new. thanks partselect
My husband removed the broken element within a few minutes & was able to install the new part in the same amount of time. Even though this was the recommended part for my oven it was slightly larger than the previous element, but all the important parts fit fine it's just a little bit longer (back to front) than the other. Oven pre-heats 3 times faster than before & cooks evenly again, very satisfied with it!
I am 75 year old female and this was a really easy job. Removed screws from rear of oven. Pulled towards me. Removed wire connections and connected to new part and replaced screws. You will notice an odor when you turn oven on. It will disappear in a few minutes. Don'T FORGET 2 TURN POWER OFF BEFORE BEGINNING
The wire connectors were burn too, that may have caused the Element to burn-up on the end. The Broiler Element wire was getting bad too, so I replaced the old connector. Everything is working fine,I'm glad you guys were there.
i took two screws out and pulled the element out unplugged the wires put the wires on new one and put it back in place and screwed it in done less than 15 min. ordered part on line Sunday and had it by that Tuesday. very fast del.
I have a wonderful range that I love and it is almost 30 years old! The baking element died...burned and broke in half. This is the second time I have had to replace it (not bad for the old girl) and the first time I used PartSelect. I ordered the part late in the day and it was delivered by FedEx in just under 24 hours....now that's service! This is a very easy repair that anyone can do. Just turn power off to range, unscrew the hexagonal screws, ease out the bad element, reattach electrodes to new one, ease it back into range, put screws back in and you are done. Ten minute job you can do yourself for the cost of the part. Great great service from PartSelect.
Oven quit heating after less than 6 years. Checked with a volt-ohm meter and determined element was open. Ordered new element. Unit arrived in good time, replaced in about 15 minutes with no problems at all. Took longer to remove and replace oven door tha it did to install element.
The PartsSelect site provided the hint that the baking element might be the root cause of low heat. SO I order the part, got it within a few days and installed it. Simple matter of removing a small read cover and tow faston connectors to the heatng element along with two Phillips screws that secured the heating element. Oven now works like new!! Thanks PartsSelect, you saved me a bundle!
Unplugged stove. Removed oven racks. Using 1/4" nut driver I removed two screws from back wall of oven that were holding bake element in place. Pulled stove from wall, removed lower back panel. Disconnected electric saber connectors. Pulled old element from oven. Put new element in oven. Reinstalled the two 1/4" screws. At the back of the stove, I reconnected the two push-on saber connections. Replaced back panel. Pushed stove back in place. Plugged in the power cord. Checked oven. Works fine.Great experience with Parts Select in every way.Total work time: about 20 minutes.
The bake element had burned through at a point near the right connect point.
I removed the old part, went on your website and found the proper replacement part ordered it and received it the next day. Two screws and the new part was in.
