MHW2000AWW Maytag Washer Dryer Combo - Parts

Foot, Front - Single

★★★★★

★★★★★

(4)

The front facing foot is sold individually. It is used on your washing machine and can also be known as an adjustable leveling leg. This specific front facing leveling leg has a rubber foot. It is imp... Add to cart

Idler Arm and Shaft

★★★★★

★★★★★

(2)

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer. Add to cart

Timer Knob Insert Cap

★★★★★

★★★★★

(1)

This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic. Add to cart

Rubber Foot Pad

★★★★★

★★★★★

(1)

The leveling leg pad or foot pad fits over the leveling leg on your washing machine. The foot pad is designed to protect your floor and keep the washing machine level and in place. This foot pad is ju... Add to cart

Idler Shaft Retaining Ring This idler shaft retaining ring is well under an inch long and is made of metal. Add to cart

Lip Seal Kit

★★★★★

★★★★★

(2)

This kit comes with grease, earlier lip seal, revised lip seal, o-ring, seal tool, and washer kit. Used primarily on front load washers. NOTE: Bearing is NOT sold separately. It is only available ... Add to cart

Drive Belt and Motor Isolator Kit

★★★★★

★★★★★

(8)

This kit contains a flat drive belt, two motor isolators, and an instructions sheet. The drive belt is made to slip on the pulley until the basket gets up the desired speed. Add to cart

Roller Shaft Hex Nut This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers. Add to cart

Idler Arm Screw Sleeve

★★★★★

★★★★★

(3)

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer. Add to cart

Screw This screw is sold individually.

High Limit Thermostat

★★★★★

★★★★★

(4)

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu... Add to cart

Hose Clamp

★★★★★

★★★★★

(2)

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installat... Add to cart