Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Light hinge broke
Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.
Before starting unplug the refrigerator 1) Remove the drip grate 2) Remove the 2 screws located at bottom of dispenser (they were located under the drip grate) 3) Remove dispenser trim plate by carefully disconnedting the touch pad wire. 4) Remove 2 screws on top right and left side of dispenser. 5) Remove 1 screw located in middle of dispenser (near the ice dam). 6) Remove Dispenser from refrigerator. 7) Completely clean the dispenser 8) Remove old Actuator Pad 9) Unscrew Limit Switch 10) Remove wire connections on limit switch. 11) Screw in new Limit Switch 12) Connect wires to limit switch (in same manner as they came off) 13) Install new Actuator Pad (make sure you align the "pusher" with the Limit switch). 14) Put the dispenser back into the refrigerator (Make sure you install the water line in its slot) 15) Install the 3 screws 16) Reconnect wire to trim plate. 17) Install 2 screws at bottom of dispenser 18) replace drip grate. 19) Plug in refrigerator 20) Enjoy water/ice dispenser that shuts off.
Had to push the light switch to get lamp to light up. Removed power from refrig. and removed old light switch and replaced with the one I got from Partselect. Turned power back on and was done.
Removed drive assembly end of ice bin using socket wrench to get to old ice bin drive ring. Pull drive sssembly back to get ice bin ring out of the other end of ice bin. Installed new ice bin ring and and reinstall drive assembly end.
just snapped the new one in. I am very happy. the part was delivered in just a few days--I was surprised how quickly it was delivered. thank you. I would use your company again.
Remove the broken part and disconnect the plug for the motor for the ice dispenser. Then I cut a hole large enough to insert the motor prongs in the new part. Made two braces to add strength where I cut and reinstalled the motor . I was not able to disengage the prongs and didn't want to brake it. Works fine. The part came in one day. Great work Parts Select!!
The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to work the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.
