EW23CS70IS1 Electrolux Refrigerator - Instructions

The bulb has a plastic clear cover. That cover can just be carefully removed using a screwdriver. It's held in by a metal bracket. After you remove the cover. You'll just need to replace the bulb and then re-install the cover and bracket.

Removed ice bucket from freezer. Remove ice. Remove 2 phillips head screws from the inside front of ice bucket, and 2 fromt the bottom front to remove the front cover. Remove the E clip and washer from ice crusher shaft. Remove 4, 1/4” head screws from ice crusher housing. Unclip the selector shaft from crusher door paying attention to position.Slide housing off of shaft and discard. Install new housing over shaft and install the 4 screws. Install selector shaft into door. Install the E clip and washer onto shaft. Install front housing with the 4 screws previously removed. Refill bucket with ice and install bucket back into freezing taking care to orient the ice screw shaft into the cog in the back of the freezer as well as the door selection shaft. Test operation.

Loosen two screws, unplug power, lift it off, put new one on and make sure water chute is correct place, tighten screws!

VERY EASY SLIDE OLD ONE OUT AND PUT NEW ONE IT

Unscrewed (loosen) screws lifted unit out unplugged electrical connection. plugged in unit hung on screws tightened screws and had ice in less then 1 hour. Rick

Had to replace with a whole new part, had to take it all apart to replace

slide old filter out and insert new one

love this super easy remove two screws and replace thank you

Replaced shelf

just slid them in and gently taped the pegs in

Replacement of the water valve repair was a snap. Only the main supply line needed to use a nut to secure the water supply. All other lines were simply cut below the pointed end of the plastic tubing line, nylon nut discarded and simply pushed in to seat with a O-ring fitting. Took no more than 10 minutes to install the new valve and test for leaks after turning water back on. This was the easiest appliance repair I have done in > 5 years, 100% success first time,

Use pliers to remove the broken support. Clear the remaining insert pieces with screwdriver/pliers and insert the replacement part.

I put the new unit up to the old one to see exactly how it goes, took the 2 screws holding the unt off...Took the 3 water lines off with adjustable wrench, put back exactly the same way and it worked with no leaks

Replaced wall pins pulling center pins removeing set new ones replaced drawers. Damm Kids Busted the old ones it was easy to find your web site , parts and purchasse items as this was a new one It was diffacullt to use drawers

The tabs were broken by kids it took 10 minutes to repair on all 4 tabs you have to remove the push pins completed to get the new tabs to fit right