11092966100 Kenmore Washer Dryer Combo - Parts

Lid Switch Kit

★★★★★

★★★★★

(10)

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. Add to cart

Lid Bumper

★★★★★

★★★★★

(4)

This gray and white washer lid bumper contains a rubber bottom and is sold individually. Add to cart

Clutch Lining Kit

★★★★★

★★★★★

(3)

This kit comes with springs, hardware, and brake lining. Add to cart

Spring Outer Bracket

★★★★★

★★★★★

(1)

Sold individually. Add to cart

Drain Hose with Clamp

★★★★★

★★★★★

(2)

Used to drain water. Add to cart

Drum Support Roller Shaft - Right Hand Threads

★★★★★

★★★★★

(1)

This front shaft with right hand threads is used in dryers. The shaft and the drum support rollers ride on to support the drum. If your shaft has flat spots and the rollers do not spin, replacing the ... Add to cart

Leveling Leg Locking Nut The leveling leg locking nut is an OEM replacement fastener for use in dryers and washers. It has a head diameter of 3/8 inches and a thread pitch of 16 threads per inch. The nut secures the leveling ... Add to cart

Inlet Hose - 5 FT

★★★★★

★★★★★

(3)

This hose can handle hot or cold water and is five feet long. Add to cart

Terminal Block - Block Only

★★★★★

★★★★★

(1)

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately Add to cart

Screw, 8-18 x 1/2 This screw is sold individually. Add to cart

WASHER

★★★★★

★★★★★

(1)

This part is located on the drum roller support shaft in your dryer appliance. The exterior of the washer is 1 inch in diameter with a hole in the middle and is made of metal. They are installed along... Add to cart

Blower Housing Seal

★★★★★

★★★★★

(4)

This part seals between the blower housing and the blower housing cover. Add to cart