Cub Cadet Chipper Shredder Tanks and Containers

Find Your Part

Model number locator Need help finding your model number?
  • Search your model number to find:
  • Genuine OEM parts guaranteed to fit
  • Free manuals and guides
  • Repair instructions and videos
Cub Cadet Appliance Parts
Shop By Part Type

Popular Cub Cadet Chipper Shredder Tanks and Containers

Your Price
$70.56
  In Stock
Cub Cadet Chipper Shredder Engine Fuel Tank
★★★★★
★★★★★
2 Reviews
PartSelect Number PS9078285
Manufacturer Part Number 699374
This fuel tank is for lawn and garden equipment engines. Fuel tank holds the gas that's needed by the engine. Work in a well-ventilated area when installing this part. Drain the existing fuel from the tank and disconnect the spark plug wire before beginning the repair.
Your Price
$98.07
  In Stock
Cub Cadet Chipper Shredder Fuel Tank
★★★★★
★★★★★
1 Review
PartSelect Number PS9141053
Manufacturer Part Number 799863
This is a replacement fuel tank for your outdoor power equipment. It is made of black plastic and comes with the tank itself, as well as the fuel cap. The fuel tank stores fuel before it is transported to the engine. Because it is made of plastic, it can occasionally crack and cause fuel to leak. The cap can also become stripped, and this can prevent a seal from forming, causing the tank to leak. This is an OEM part sourced directly from the manufacturer.
Your Price
$165.79
  In Stock
Cub Cadet Chipper Shredder Tank-Fuel (Black Plastic)
PartSelect Number PS9294765
Manufacturer Part Number 691993
Installation Instructions
Dennis from EUFAULA, OK
Gas tank leaking, pull starter rivets worn, rope and rope bushing worn
The gas tank was a simple job, close the fuel shut off, remove fuel hose then back out 2 bolts on the mounting bracket. Reverse procedure to mount.
To replace the pull starter/recoil assy. Remove low oil warning light, and air filter housing then remove the 4 bolts holding the front cover. Once the front cover is free remove kill switch wire
Drill out the rivets holding the recoil housing w/ 3/16 bit. Screws w/ nuts are included to use in place of rivets, I used red Locktite on the screws which hold the started recoil to the front cover. Make sure the pull rope is correctly oriented in the 11:00 position. Replace front cover, four bolts. Air filter housing, kill switch wire and low oil warning light Read more...

Related Cub Cadet Chipper Shredder Parts

Back to Top