Toro Snow Blower Seals and Gaskets

Your Price

$6.59

Toro Snow Blower Seal,Oil

★★★★★

1 Review

PartSelect Number PS9277860

Manufacturer Part Number 391086S

The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "Medium" difficulty and requires a screw driver, wrench set and seal puller. A broken seal will cause a leak, and the part must be replaced. Refer to your make, model and diagram to ensure you're choosing the right part. This part comes in black and gray.

Your Price

$5.71

Toro Snow Blower Gasket--Exhaust

PartSelect Number PS9294808

Manufacturer Part Number 692236

This OEM exhaust gasket in lawn and garden equipment creates a seal between the engine block and the muffler or exhaust pipe so that exhaust gases do not leak. This is 3.30cm in diameter and 6.35cm in length. Your machine may have a loud hissing or popping sound coming from the exhaust area if the gasket was faulty. You may also notice the presence of black soot around the gasket or the exhaust. Your gasket needs to be replaced if it appears worn or deformed. Otherwise, your machine will experience exhaust leaks. To detach the gasket, remove the fasteners that secure it using a socket or wrench. You can detach the gasket from your machine afterwards. Please bear in mind that this replacement part is sold individually.

Installation Instructions

FRANK from EASTANOLLEE, GA

Screw can out of the carburator throttle baffel and stuck in the exhaust valve

No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!! Read more...

Your Price

$4.99

Toro Snow Blower Gasket-Float Bowl

PartSelect Number PS9064482

Manufacturer Part Number 693981

Your Price

$5.99

Toro Snow Blower Seal-Oil

PartSelect Number PS8948679

Manufacturer Part Number 299819S

This OEM Oil Seal is an individually sold rubber part which is attached around the axis shaft on the crankcase housing to provide a proper seal. A broken seal will lead to a leak, and the part should be replaced. Installation is rated as "Medium" difficulty by customers, and will require a screwdriver, wrenchset and seal puller. Refer to your make, model and diagrams to ensure you've chosen the correct part. This model comes in black and grey.

Your Price

$7.59

Toro Snow Blower Seal-Oil (PTO Side)

PartSelect Number PS8947568

Manufacturer Part Number 291675S

Your Price

$8.91

Toro Snow Blower Seal-Dipstick Tube

★★★★★

2 Reviews

PartSelect Number PS9274579

Manufacturer Part Number 281370S

Your Price

$5.71

Toro Snow Blower Gasket- Exhaust

★★★★★

1 Review

PartSelect Number PS9294810

Manufacturer Part Number 692237

Installation Instructions

Alberto from PALMETTO BAY, FL

Generator would not start, Birggs & Stratton recommended to replase Gasket Exhaust.

Remove the spark suppresser, 4 face screws, 2 bottom screws and the two screws the hold the gasket. I also had to back out the top screw of the cover it blocked and prevented the removal of the gasket. Read more...