Control Board 191652GS

Hi Philip, Thank you for your question. I believe the part you are looking for is the capacitor. The capacitor has two functions; it induces voltage into the rotor as well as regulates voltage. A bad capacity will result in a low voltage reading from the generator as the power being generated will be from the residual magnetism of the rotor (usually about 2-5V). To test a capacitor, a multi-meter that can test capacitance is required. To test a capacitor, it must first be removed from the generator and discharged. Be careful when removing the wire leads that a short is not created across the capacitors terminals. To discharge, use a screwdriver with an insulated handle to cross the terminals on the capacitor (this will result in a loud pop and a spark). Once discharged, take a reading from the capacitor. The measured capacitance should be +/-5uf of the specified rating printed on the side of the capacitor. If not, the capacitor should be replaced. I hope this helps. Thank you and have a great day!