Average Repair Rating: 3.8 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Buttons were missing and board was broken .
Ordered new parts and was very easy to repair .and it works great. I removed air vent on top of microwave.and removed all the screws that held on the front panel and unplugged all wires and removed broken button panel and replaced it. reassemble and tested all worked well.
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Hector
December 3, 2017
How can I disassemble where the keypad is in order to replace it with a new select button?
For model number smh9207st
Hello Hector,
Thanks for your question. Disconnect the microwave's power and remove the grille by taking out two screws and sliding the grille to the left, then pulling it out. Take out the screw securing the control box
assembly to the frame and disconnect the connectors from the control circuit board.
Pull the lever end of the plastic fastener and remove the Flexible Printed Circuit off the
membrane panel, then take off the three screws securing the control circuit board.
Lift up the control circuit board. Replace the button and reverse the procedure. Be sure the
holes on the Flexible Printed Circuit connector are properly engaged with the hooks on the plastic fastener.
I hope this helps.