We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
6 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Lawrence
September 14, 2017
Since there is no picture, i am not sure if this is the correct part. The lid pin (holds the lid (cover to the deli drawer) broke off the right side (has the temperature control) . Let me know if this is the correct part. Thanks,
For model number KBFS20EVMS7
Hi Lawrence,
Thank you for your question. You would actually need to replace your end cap to replace that lid pin. I have linked the part down below for you. Good luck with your repair.
The long white plastic that is in the middle of the 2 veg & fruit draws for support they glide in it . I have replaced it once but can t find my paper work
For model number G16SARXXF05
Hello Marian, thank you for your question. The center rail for the two crisper bins is Part Number: PS11752912. Good luck with your repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Chris
September 7, 2021
Freezer drawer closes tighter on one side than the other. The drawer gears don stayed aligned from one side to the other. I think it's the closing motor that pulls the drawer shut. I don't see it in any diagram.
For model number WRF540CWHV00
Hello Chris, Thank you for the question. The Freezer door does not require a Closing Motor. The door uses the Rails and Gears to close. We suggest removing the Freezer Drawer to check the parts to the Rail and the Gears for wear or damage. We hope this helps!
The little white pin on the right side that fits into the wide and fresh deli drawer broke off the tip (pin part that fits into the hole) can i just glue it with an appoxy? Or how would i replace just the tip/pin? Thank you!
For model number MFF2558VEW1
Hi Jen,
Thank you for your question. If you would like to glue the part back on that would be up to you. However if you are looking to replace that part, it is part of your end cap. I have attached the correct part in a link below for you. Good luck with your repair.
Can you tell me what the part number is for the right side for the meat department that I will need. The top broke that holds the lid down.
For model number MFF2258DEE00
Hello Karen, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS12578233. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
There is a pin guide on the top drawer of the freezer. A bar fits into it on both sides to guide the door to roll shut same on both sides. The right side is broken where bar fits in. What part is this?
For model number Wrf555sdhw02
Hi Sonja, thank you for reaching out. The part that you are looking for is the slide, part number PS12711301. We hope this information helps!