Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Michael M - August 28, 2018
Verified Purchase
Returned
The part was returned and confirmed received .I should be credited the amount immediately . Thanks
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 5.0 / 5.0, 1 reviews.
What's this?
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Refrigerator/Freezer not getting cold.
Determined that compressor was not running, after researching problem on another site they recommended i try the condenser moor fan or motor, the defrost thermostat or defrost timer. . I was not satisfied with their recommendations. If I had tried their recommendations i would have likely gotten frustrated and spent upwards of $3000 to
... Read more replace the 22 year-old hand me down unit. Thank you Parts Select for properly diagnosing my relay failure saving me a ton of money.
Read less
Calvin from KELLER, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
3 questions answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
EDNA
April 3, 2019
Do the white,blue wire come with the part.
For model number 1108190
Hello Edna, Thank you for the question. Very sorry we do not carry the wiring, just the part. Hope this helps, good luck with this repair!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Albert
October 29, 2019
How does the relay looks like. There is round one on the top attached to the compressor and the other rectangle below with wires blue and red and how do you disconnect it.
For model number ED22GW
Hello Albert, Thank you for the question. We have a picture on the site of this relay, it would be best to look at the pictures. The wires just pull off the terminals on the relay. Hope this helps!
Was this helpful?
Thank you for voting!
Gary
October 16, 2022
compressor will not start, it trips the GFI relay when plug into the power outlet. Would bad starter relay cause this?
For model number et25dmxvno3
Hello Gary, thank you for writing. There are a few reasons an air compressor can trip a GFI, electrical and mechanical. Most commonly, the motor is pulling too much amperage but before diving into the electrical circuit. Inspect for mechanical issues, such as the pump being stiff or locked up. Or, it may be caused by multiple appliances being plugged into the same circuit. To avoid this happening, make sure that your compressor has a dedicated circuit. Good luck and have a great day.