This screw, known as a handle fixer, is used to keep the door handles on your refrigerator secure. This screw is a genuine OEM part that comes individually, and simply screws into place in your refrig...
$10.64
In Stock
Order within the next 12 hrs and your part ships today!
The Samsung Defrost Sensor (DA32-10105R) is a genuine part designed specifically for Samsung refrigerators. This sensor, sometimes referred to as a defrost thermostat or defrost temperature sensor, is...
$35.77
In Stock
Order within the next 12 hrs and your part ships today!
This door bin, also known as a door shelf or door basket, is specially designed for Samsung refrigerators. It is a storage compartment that is made to fit in the center of the fresh food door. The doo...
$84.83
In Stock
Order within the next 12 hrs and your part ships today!
This is a power cord made for Samsung refrigerators. If your current power cord is damaged, broken, or no longer supplying power to your fridge, you can disconnect it from the wall outlet, strip it fr...
$66.88
In Stock
Order within the next 12 hrs and your part ships today!
This gray dispenser lever is located on the outside of refrigerator door. When pressed, it releases the water or ice from the dispensing system. It needs to be replaced when the lever becomes loose, s...
$26.20
In Stock
Order within the next 12 hrs and your part ships today!
I performed the repair to my own refrigerator, after watching multiple YouTube videos. I installed a secondary heater for the defrost coils and replaced the defrost sensor. The defrost sensor was actually bad. Today, 1/27/2024 I rechecked the fix from last week. All seems to be good so far.
If I get any build up of any ice on t
... Read morehe bottom tray of the recessed panel where the drain port is located. I suspect I will also need a new Defrost Heater as well. For now the refrigerator is operating as expected. There is a small amount of ice build up as of today.
Also, I had recently replaced the drain tubes, added a longer heater element part to fit the drain hole, and cleaned the fins in the back of the refrigerator. Thank you.
Took off the plastic panel in the interior. As usual, the evaporator was completely iced up. Took most of the time to de-ice it with a heat gun. Tested the components and the temperature sensor was bad which is on the top end of the evaporator fins. The ohms test wasn't any different whether hot or cold. I keep a spare sensor on hand beca
... Read moreuse this is the third time one of the sensors have failed. The proper readings are available by doing some internet searching. Its been two weeks since I worked on it and everything is working fine.
A couple of blogs said the freezer defrost sensor should be replaced, so I ordered one. Did not fix it. I did, however find a service manual online and one of the blog sites and it showed me how to remove the inside duct work. I discovered the fan the recirculates the air across the evaporator coil was not working. Ordered a new fan mo
... Read moretor and installed it, fridge works perfectly now.