This screw, known as a handle fixer, is used to keep the door handles on your refrigerator secure. This screw is a genuine OEM part that comes individually, and simply screws into place in your refrig...
This evaporator fan motor is in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. When the evaporator ...
This is a crisper drawer for models of Samsung refrigerators. Crisper drawers are used to store fruits and vegetables at a different humidity level from the rest of the fridge to preserve their freshn...
The door reed switch magnet attaches to the door to open or close the reed switch as the door is opened or closed.
$8.25
In Stock
Questions And Answers for RS267TDRS
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Sterling
May 5, 2023
I have the display with 5 E and I want to set so I have ice and water dispensing.
For model number RS267TDRS
Hello Sterling, thank you for writing. The 5E indicates a fault of the temperature sensor PS4138652. We hope this helps.
Remove shelves then at bottom is a cover that holds fan in place remove a total of 6 screws. 2 of them are behind lamp lens cover you have to remove lamp lens to see them. Then use hair dryer to melt ice to allow cover to come off. Slow remove cover top left side there are two connector you have to disconnect. Then there are 4 screw to pu
... Read morell fan Assy from cover. 1 screw to get to fan motor.on fan cage remove coil spring then pull cage of . Then unplug connector from fan motor. Note to clean drain hole I use a small hose/ funnel and warm water to open hole back up.
It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.