The Samsung Defrost Sensor (DA32-10105R) is a genuine part designed specifically for Samsung refrigerators. This sensor, sometimes referred to as a defrost thermostat or defrost temperature sensor, is...
$35.77
In Stock
Order within the next 7 hrs and your part ships today!
This genuine OEM water filter is made for your side-by-side or French door refrigerator, working to reduce impurities like iron, chlorine, and rust for better-tasting water. With a capacity of 300 gal...
$124.92
In Stock
Order within the next 7 hrs and your part ships today!
This fan motor is compatible with most frost-free Samsung refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the ...
This is a refrigerator ice dispenser lever. It is clear and made entirely out of plastic. The function of the ice dispenser lever is to dispense ice when the lever is pushed. If the lever is cracked o...
Unplugged Unit Removed back cover removed fan assembly removed fan balde opened motor case replaced motor sealed the motor case fastened to fan shroud re installed fan blade re attacehd to frig- Carefull of the coolant lines Plugged in motor assembly Replaced back cover Re Plugge
... Read mored in Frig to AC outlet.
I performed the repair to my own refrigerator, after watching multiple YouTube videos. I installed a secondary heater for the defrost coils and replaced the defrost sensor. The defrost sensor was actually bad. Today, 1/27/2024 I rechecked the fix from last week. All seems to be good so far.
If I get any build up of any ice on t
... Read morehe bottom tray of the recessed panel where the drain port is located. I suspect I will also need a new Defrost Heater as well. For now the refrigerator is operating as expected. There is a small amount of ice build up as of today.
Also, I had recently replaced the drain tubes, added a longer heater element part to fit the drain hole, and cleaned the fins in the back of the refrigerator. Thank you.
Took off the plastic panel in the interior. As usual, the evaporator was completely iced up. Took most of the time to de-ice it with a heat gun. Tested the components and the temperature sensor was bad which is on the top end of the evaporator fins. The ohms test wasn't any different whether hot or cold. I keep a spare sensor on hand beca
... Read moreuse this is the third time one of the sensors have failed. The proper readings are available by doing some internet searching. Its been two weeks since I worked on it and everything is working fine.
