This screw, known as a handle fixer, is used to keep the door handles on your refrigerator secure. This screw is a genuine OEM part that comes individually, and simply screws into place in your refrig...
$10.64
In Stock
Order within the next 5 hrs and your part ships today!
The Samsung Defrost Sensor (DA32-10105R) is a genuine part designed specifically for Samsung refrigerators. This sensor, sometimes referred to as a defrost thermostat or defrost temperature sensor, is...
$35.77
In Stock
Order within the next 5 hrs and your part ships today!
This Samsung hex screw is a genuine OEM replacement fastener that is designed for the refrigerator door handle. It is a stainless steel screw that secures the handle to the refrigerator door. It is re...
$10.64
In Stock
Order within the next 5 hrs and your part ships today!
This is a power cord made for Samsung refrigerators. If your current power cord is damaged, broken, or no longer supplying power to your fridge, you can disconnect it from the wall outlet, strip it fr...
$66.88
In Stock
Order within the next 5 hrs and your part ships today!
This is a crisper drawer lid for various models of Samsung refrigerators. This lid allows you to open and close it to gain access to the contents inside the crisper drawer and maintain the level of hu...
$53.72
In Stock
Order within the next 5 hrs and your part ships today!
I performed the repair to my own refrigerator, after watching multiple YouTube videos. I installed a secondary heater for the defrost coils and replaced the defrost sensor. The defrost sensor was actually bad. Today, 1/27/2024 I rechecked the fix from last week. All seems to be good so far.
If I get any build up of any ice on t
... Read morehe bottom tray of the recessed panel where the drain port is located. I suspect I will also need a new Defrost Heater as well. For now the refrigerator is operating as expected. There is a small amount of ice build up as of today.
Also, I had recently replaced the drain tubes, added a longer heater element part to fit the drain hole, and cleaned the fins in the back of the refrigerator. Thank you.
Took off the plastic panel in the interior. As usual, the evaporator was completely iced up. Took most of the time to de-ice it with a heat gun. Tested the components and the temperature sensor was bad which is on the top end of the evaporator fins. The ohms test wasn't any different whether hot or cold. I keep a spare sensor on hand beca
... Read moreuse this is the third time one of the sensors have failed. The proper readings are available by doing some internet searching. Its been two weeks since I worked on it and everything is working fine.
