Models > GFSS2HCYCSS > Symptoms > Freezer not defrosting

Parts That Fix General Electric Refrigerator GFSS2HCYCSS Freezer not defrosting

Freezer not defrosting is a commonly reported symptom for the GFSS2HCYCSS General Electric Refrigerator, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your GFSS2HCYCSS General Electric Refrigerator that will fix Freezer not defrosting. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!

Fixes Symptom 61% of time
★★★★★
★★★★★
18 Reviews

Rated by 103 customers 

  

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.   

This defrost termination thermostat (Defrost Limiter Thermostat, High Limit Thermostat, Refrigerator Defrost Bi-Metal Thermostat) acts as a safety device to stop the evaporator coil from overheating, by turning off the defrost heater at the end of the defrost cycle. This part attaches to the tubing of the evaporator coil in the freezer. A faulty defrost termination thermostat may result in the defrost heater never heating and a solid frost buildup on the evaporator coil, which results in too warm temperatures. The thermostat contacts are normally closed and have continuity until it reaches 140 degrees. If this high limit thermostat is open at room temperature or colder, it is defective. This limit thermostat has an attached mounting clip and comes with pink and amber wire leads. The thermostat is 1 inch in diameter and 1/2 inch thick, the 2 wire leads are 10 inches long.

$ 29.24
  In Stock
PartSelect Number PS1017716
Manufacturer Part Number WR50X10068

Replacing your General Electric Refrigerator Defrost Thermostat

Replacing your Defrost Thermostat

Customer Repair Stories

freezer was freezing up.

took the back off and defrosted with a hairdryer. disconected the part pulled the part out cut the wires. put the other part on and instaled it. put it back together and it seems to be working just fine. thank you
  • doyle from kingston, WA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Socket set
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

Ice cubes froze in the tray and frost was all underneath

I read stories from the website how others did it so I figured I would give it a try. I put all the frozen stuff in the refrigerator piled up. Took out the shelves. Took out 2 screws with a socket extension ( nut driver will work fine.) Remove the light bulb. lifted up on the back panel...it came right out. Saw the coils and on top the sensor. Took it off, cut the wires, spliced in the color coded new one ( pink to pink, orange to orange) Stuck it in the top coil in the original position and crossed my fingers! I put all the pieces back easily, restocked the freezer and waited. HOORAY!! My ice cubes are all separate and free. NO frost inside. A very easy fix for $20.

Note: If there is a large amount of ice build up on your coils a hair dryer works great. The drain is on the bottom anyway. Also , you may want to seal around the wire nuts to keep moisture out. I did
  • Michael from Sylva, NC
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Socket set
5 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Fixes Symptom 39% of time
★★★★★
★★★★★
66 Reviews

Rated by 44 customers 

  

Easy 

30 - 60 mins 

Ratings submitted by customers like you who bought this part.   

This sensor (Temperature Sensor, Thermistor, Refrigerator Temperature Sensor) sends the temperature reading of the compartment to the control board. If you notice your refrigerator is too warm, too cold, or not defrosting properly, then there may be a problem with your sensor. The temperature sensor can break from material fatigue or through normal use, and should be replaced. It is attached to the evaporator and control housing in your appliance. It measures approximately 1.25 inches long with 18 inch wire leads, and is constructed out of plastic. This part comes in white, beige. It includes the sensor, with wire leads.

$ 26.97
  In Stock
PartSelect Number PS304103
Manufacturer Part Number WR55X10025

Replacing your General Electric Refrigerator Temperature Sensor

Replacing your Temperature Sensor

Replacing your General Electric Refrigerator Temperature Sensor

Replacing your Temperature Sensor

Customer Repair Stories

refrigerator was getting too cold

I removed the old temperature sensor by cutting the wires. I attached the wires of the new sensor with wire nuts and mounted it in the same bracket.
  • Larry from Menomonie, WI
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
145 of 203 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!

my refigerator was warm but the freezer was cold and working correcttly

I went to a GE repair center to explain my problem, the service center reccomended that I have a techinician come out o look at it. $75.00 for the visit and what ever labor and materials wuld cost.

I went on line to see if there were others having this same problem and found that there were many with the same problem.
  • michele from North Smithfield, RI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers
277 of 348 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!