Make sure you haven't got the discount earlier.
Parts That Fix Frigidaire Dishwasher FDPC4221AW0A Leaking
Leaking is a commonly reported symptom for the FDPC4221AW0A Frigidaire Dishwasher, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your FDPC4221AW0A Frigidaire Dishwasher that will fix Leaking. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!
This grey OEM dishwasher tub gasket is a 73" grey rubber part that creates a seal around the dishwasher to prevent any water leakage during a cycle. If it's damaged or broken, you'll start seeing water leaking out. If broken, it should be replaced. Refer to your model number and user manual to ensure this part is right for you. When making this repair, open the dishwasher door and take out the lower dish tray for better access. Pull out the old gasket, and clean the channel with a rag. Push the new gasket into place into the notch on the door, which you should see upon close inspection, using a flat-head screwdriver for assistance if necessary. We do not recommend cutting any additional length off on the tub gasket if any is present during your repair.
Replacing your Frigidaire Dishwasher Dishwasher Tub Gasket - Gray
Customer Repair Stories
Dishwasher was leaking at the lower left side of the door.
Water leak solved...
-
John from Hummelstown, PA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
dishwasher was leaking water
-
Charles from Milton, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
This door seal is for dishwashers. Door seal seals the gap between the opening to the dishwasher tub and the outer edge of the door. After installing the door seal, shut the dishwasher door and leave the door closed for several hours to properly seat the new door seal.
Customer Repair Stories
Replace lower gasket on dishwasher
-
Steve from GERMANTWN HLS, IL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Dishwasher leaking at the bottom of door
-
Richard from CASTLE ROCK, CO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
If your dishwasher is leaking or not draining properly, you may need to replace the drain hose. The drain hose connects to the pump located below the lower spray arm and aids in proper dishwasher drainage. This white and black plastic hose is 7.5 feet long. For this repair, you will need either a 1/4-inch or 5/16-inch nut driver, depending on your model. You will need to remove the lower access panel on your dishwasher to complete this repair; it is often easier to remove the dishwasher from the cabinet to do so. Be sure to disconnect the dishwasher from both the power and water supply before completing this repair.
Replacing your Frigidaire Dishwasher Dishwasher Drain Hose
Customer Repair Stories
A hole in the dishwasher dicharge hose.
-
Lee from Columbus, OH
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers
Drain hose was missing
-
John from Carthage, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench set
The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broken (due to general wear or high heat), it should be replaced. Your lower spray arm will be located at the bottom of your dishwasher tub. Check your user manual and model number to ensure this model is right for you. This version is plastic and metal and comes in gray/blue. We recommend you wear work gloves to keep your hands safe when installing and disconnect power to the appliance. You will also want to make sure that you turn off the water supply to your dishwasher. From here, you will want to open the dishwasher, pull out the lower rack and set it aside. Remove the lower wash arm. On each side of the bottom of the spray arm, there are small locking tabs that can be pushed aside using a flathead screwdriver. Once released, the spray arm can easily be pulled off the dishwasher. Put the new lower wash arm in place and push it down to lock it in. Ensure it is spinning freely and does not hit the heating element. Return the lower dish rack into place and then close the dishwasher door.
Replacing your Frigidaire Dishwasher Lower Spray Arm
Customer Repair Stories
Spray arm fell over and melted on the heating element.
-
Inge from Hernando, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
spray arm keeps melting
-
Donna from Madison, OH
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
The tubing carries water from the water inlet valve to the tub.
Replacing your Frigidaire Dishwasher Dishwasher Water Inlet Tubing
Customer Repair Stories
Water fill hose leaked.
-
Thomas from Wheaton, IL
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
Old hose was split
-
Sandra R. from Groveland, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
Water is supplied to the upper arm through this tube via the pump assembly.
Replacing your Frigidaire Dishwasher Water Supply Feed Tube
Customer Repair Stories
Leaking
-
Thomas from W HEMPSTEAD, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Wrench (Adjustable)
Wouldn't fix it
-
Carolyn from STILWELL, OK
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
Sold individually.
Replacing your Frigidaire Dishwasher Delivery Tube Gasket
Customer Repair Stories
Spinner fell off of delivery tube.
-
Jeffrey from Rougemont, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
Dishwasher Leakibng
Unplugged dishwasher and slid it out from cabinet area (be sure to turn off and disconnect water supply)
Followed delivery tube up side of dish ... Read more washer to top of tub and noticed reminents of where water ran down side of tub.
Loosened delivery tube by plastic nut inside of tube and removed. Noticed gasket was partially depleted.
Ordered new gasket, replaced and put everything back together. (Be sure to use teflon tape on water source fitting and tighten firmly). No leaks
-
Eric from Benton, KY
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Wrench (Adjustable)
This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher. NOTE: Brass nuts are NOT included. Must be ordered separately.
Customer Repair Stories
Heating Element was corroded.
-
Christopher from EVERETT, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Screw drivers, Wrench (Adjustable)
Heating element went out
removed the c-clips holding element underneath
and put new one in. Hard part was figuring out
what was holding the element but since I still
had the schematic drawing we figured it out.
Saved a bunch on a repairman. After watching
my friend install the new eleme ... Read more nt I could probably
do it myself next time.
-
Jane from Port Charlotte, FL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers, Wrench (Adjustable)
Sold individually.
This grommet fits on the spray arm of your dishwasher. This replacement part connects and seals the spray arm to the water hose that supplies water to the dishwasher tub. Be sure to shut off water supply to your appliance before completing this repair. This part is 3 inches in diameter and is off-white in color.
Replacing your Frigidaire Dishwasher Water Delivery Tube Grommet
Customer Repair Stories
Replacing grommet
-
Jack from KENDALLVILLE, IN
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Pliers, Screw drivers
wrong part
Now i am back at square one with part I don't need and hoping for the part I do need
-
Loraine from HYDE PARK, VT
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
Water that fills your dishwasher lifts the float. When it reaches a certain level, the float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.
Replacing your Frigidaire Dishwasher Float Switch
Customer Repair Stories
machine was not filling
-
jon from northampton, MA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
No water to dish washer
-
steve from virginia beach, VA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
This lower spray arm is a genuine OEM part for various makes and models of dishwasher and is sold as an individual part. This part attaches to the lower spray assembly of your dishwasher and the lower spray arm itself clips into this part to facilitate its spinning movement during the washing cycle. To replace it, remove the spray arm by pulling it out, remove the surrounding circular clip and then twist to remove this bit. Made completely of plastic, this part measures approximately 3-inches deep, 2-inches wide, and 3.125-inches tall.
Replacing your Frigidaire Dishwasher Lower Spray Arm Support
Customer Repair Stories
missing bottom spray arm
-
Ashley from Normal, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
spray arm fell off and melted on element
-
Dale from Worley, ID
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Customer Repair Stories
Dishwasher leaks
-
Gardner from Old Saybrook, CT
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Nutdriver, Screw drivers, Socket set
As water is filling your dishwasher, a float rises along with it. When the float reaches a predetermined level, it shuts off the flow of water, thereby preventing a leak.
Replacing your Frigidaire Dishwasher FLOAT
Customer Repair Stories
was brocken
-
Aleksandr from West Palm Beach, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Replacing your Frigidaire Dishwasher Door Hinge Kit
This is an OEM center spray arm, which works with dishwashers.
Customer Repair Stories
The Center Spray Arm was broken
-
YVES from VALLEY STREAM, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
This is the replacement detergent dispenser for your refrigerator. It is gray in color and is sold individually. It is approximately 8.5 inches long and 3 inches wide. The detergent dispenser stores the detergent until it is ready to be dispensed. If your dishes are not coming clean, or you notice the detergent is still in the dispenser at the end of the cycle, you may have a damaged or malfunctioning detergent dispenser. This is an OEM part sourced directly from the manufacturer.
Replacing your Frigidaire Dishwasher Detergent Dispenser
Customer Repair Stories
Leaked spot free fluid
-
Tim from MARINE ST CRX, MN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
The soap dispenser didn’t dispense the soap
-
Bernard from ACUSHNET, MA
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers