General Electric Washer Dryer Combo Switches

Your Price

$18.18

General Electric Washer Dryer Combo Push-to-Start Switch

★★★★★

26 Reviews

PartSelect Number PS3487190

Manufacturer Part Number WE4M416

This switch is used to activate the dryer.

Fixes these symptoms

Touchpad does not respond
Will Not Start
Won’t Start
See more...

Installation Instructions

Gary from LAVALLETTE, NJ

replaced start button and start switch

disconnect power plug unscrew 3 screws in back. lean forward remove button disconnect 2 wires in back of switch. put switch connect 2 wires and button. connect 3 screws in the back. ready to start working Read more...

Videos!

Your Price

$27.42

General Electric Washer Dryer Combo Interlock Switch

★★★★★

18 Reviews

PartSelect Number PS1481922

Manufacturer Part Number WD21X10261

The interlock switch may also be referred to as a belt switch. This part is a simple on/off mechanism that prohibits the appliance from operating when the door is open. This is a part for your dryer. The interlock switch senses the door is shut and the dryer can begin. This part might need to be replaced if your dryer is not starting or is in process while the door is open. The black rectangular part of the switch is approximately 2 inches long and a 1/2-inch wide with two gold plates on either end. This is a genuine OEM part that is sourced right from the manufacturer.

Fixes these symptoms

Door latch failure
Will Not Start
Won’t Start
See more...

Installation Instructions

Steven from EPHRATA, WA

interlock switch was bad. Prevents the dishwasher form running as it "thinks" the door is still open.

Opened door, removed screw holding down metal plate that presses against interlock switch when door is closed. Removed plastic cover thingy that is over interlock switches. Removed the interlock switch by pressing the plastic lock thingy away from switch. Pulled the wires off each end of the interlock switch. Removed new interlock switch from plastic bag and reversed above procedure. Done, shut door and the dishwasher works. Read more...

Videos!

Your Price

$32.46

General Electric Washer Dryer Combo Door Switch

★★★★★

6 Reviews

PartSelect Number PS2344321

Manufacturer Part Number WE4M415

A door switch is a simple on/off mechanism that prohibits the dryer from operating when the door is open.

Fixes these symptoms

Won’t Start
See more...

Installation Instructions

Joshua from Dallas, TX

Dryer would not start

The end repair was very simple and took minimal effort. The time and difficulty was all in the testing. I disassembled the dryer and removed the drum and then hard wired each thermo-fuse to determine where the fault was. After test all of those I was stumped. When I opened the door the light would not come on so I assumed it was a power fault closer to the source. However after all of my testing I couldn't find anything wrong. I then removed the light bulb and realized it was burned out which led me to the door switch being the fault. I removed the switch and soldered the three wire together and the dryer started right up! All I had to do was order a new $15 part, unsolder the wires and plug them in. Would have been so much simpler if that light bulb hadn't of been burned out causing me to over think my diagnosis. This was my first major appliance repair and I did it with only the help of the parts diagram provided on the website. Read more...

Your Price

$11.41

General Electric Washer Dryer Combo MAGNET

PartSelect Number PS3496866

Manufacturer Part Number WH01X10626

Your Price

$23.91

General Electric Washer Dryer Combo SWITCH SELECTOR

PartSelect Number PS3499720

Manufacturer Part Number WH12X10510

Your Price

$133.14

General Electric Washer Dryer Combo Lid Switch

★★★★★

4 Reviews

PartSelect Number PS270219

Manufacturer Part Number WH12X955

Used with washer/dryer combos. This part makes sure that the lid is shut before allowing the machine to start or agitate.

Fixes these symptoms

Will not drain
See more...

Installation Instructions

Cami from Roswell, GA

Broken lid switch (old part worked, but plastic casing broke and screws couldn't hold it in place anymore)

The removal and installation were self-explanatory once the part was in hand. Because the unit is in a laundry closet off the bathroom, space was limited and we had to be creative. Hence, my son's Handy Manny tool set, Turner to be exact, was perfect for holding the ground wire bolt in place from behind the dryer lid so that we could loosen the nut on the inside of the dryer lid. Of course, when I went to put the nut back on the bolt after putting the new ground wire in place, I dropped the nut in the dryer. That's when our son's Harvey the train (a Thomas the Tank engine character) came in handy. My long arms and its magnet were just the thing to get the nut out of the abyss at the bottom of the washer cabinet. Read more...