Bosch Dishwasher Caps and Lids

Your Price

$7.86

Bosch Dishwasher HANDLE-CAP SHAPED

★★★★★

4 Reviews

PartSelect Number PS8729301

Manufacturer Part Number 00628998

This door handle end cap is supplied directly by the manufacturer for use with dishwashers. It is a genuine OEM part that is designed to fit just like the original piece. The end cap is made of highly durable plastic, and it is responsible for securing the end of the handle on the dishwasher door. It protects the handle from scratches, dents, and general wear and tear, which can occur over time. It also contributes to the appearance of the dishwasher by concealing any exposed screws and providing a finished look to the handles. When replacing the end caps, you will need to first remove the door panel. Each end cap is sold individually.

Fixes these symptoms

Door latch failure
See more...

Installation Instructions

Robert from VERONA, NJ

Handle caps at both ends of dishwasher door cracked and needed to be replaced

Followed You Tube video how to replace door handle caps and used above mentioned tool. Note: could not use a regular screwdriver. Read more...

Your Price

$17.42

Bosch Dishwasher LID

PartSelect Number PS8727344

Manufacturer Part Number 00611322

Fixes these symptoms

Not draining
See more...

Your Price

$18.67

Bosch Dishwasher LID

★★★★★

3 Reviews

PartSelect Number PS8697157

Manufacturer Part Number 00166623

This OEM-sourced detergent dispenser cover, also known as a rinse aid dispenser lid, seals and protects the detergent compartment in your dishwasher. Typically located on the inner door, it covers the detergent dispenser assembly. When loading the dishwasher, you lift the cover to add rinse aid before running a cycle. If the detergent dispenser cover is broken, you may notice visible cracks, chips, or it may not stay in place properly. If left unreplaced, it can result in detergent leakage during the wash cycle. To remove the cover, first, turn off the power and water supply. Open the dishwasher door and gently insert a flathead screwdriver between the dispenser body and the cover, prying it off. When installing the replacement cover, align it at an angle with the housing and fit one side in before rotating it to snap into place.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

Sue E from CARMEL, IN

Rinse aid dispenser lid would not stay closed

Use a screwdriver flat blade to pry up one edge of closed lid. Put one side of lid into hinge and snapped other side into place. Very easy. Read more...