Crosley Dishwasher Springs and Shock Absorbers

Videos!

Your Price

$43.81

Crosley Dishwasher Door Spring

★★★★★

10 Reviews

PartSelect Number PS1524996

Manufacturer Part Number 154579101

Sold individually.

Fixes these symptoms

Door latch failure
Door won’t close
Noisy
See more...

Installation Instructions

John from SIERRA VISTA, AZ

Left side door spring replacment

First thing I did was turn off the power to the dishwasher, then remove the racks. Remove the foot plates, remove the two top screws holding the dishwasher. Then using the socket set, retract the two foot stands to pull the dishwasher forward. You may not have to do this step as I had to get it over tile. The pully springs are on the sides, easily replaced. After replacing the springs and I recommend replacing both at the same time, put everything back. The hardest part will be the foot plates, there are two and getting them lined up and the screws back in is a bit of a challenge. Then you are done. Read more...

Videos!

Your Price

$35.02

Crosley Dishwasher Door Spring

★★★★★

9 Reviews

PartSelect Number PS815938

Manufacturer Part Number 154430501

This door spring is manufactured for a dishwasher door. The door spring applies tension to the dishwasher door so that the door does not drop too quickly when it is opening. If the door drops too quickly, it could cause damage to the dishwasher door or dishwasher door hinges. This spring is sold individually. Check the spring on the opposite side of the dishwasher door, they often wear at the same rate so you may want to replace both springs for exact tension on either side. No tools are required for this repair. This is an OEM replacement part.

Fixes these symptoms

Door latch failure
Door won’t close
See more...

Installation Instructions

Daniel from Fremont, NE

Dishwasher door practically fell open

All I had to do was replace the spring and retainer on the side of the dishwasher which amounted to pulling it out far enough to reach the eyelet that the hook went into and then stretching it to the retainer attached on the other end. I really like partselect, I have done some things in the past and they are very helpful on the site and on the phone and I would recommend them to anyone and I would not normally do that unless it has been an excellent experience. Read more...

Videos!

Your Price

$43.20

Crosley Dishwasher Door Spring

★★★★★

7 Reviews

PartSelect Number PS724932

Manufacturer Part Number 154430601

Sold individually.

Fixes these symptoms

Door latch failure
Door won’t close
See more...

Installation Instructions

Michael from Redmond, WA

One of the door tension springs and related plastic clip failed causing door to open under full weight

Per the recommendation from PartSelect.com, I purchased 2 new springs and 2 new clips - one set for each side. With the bottom cover plate removed below the door, I removed the remaining spring and clip and installed the 2 new springs and clips by hand. The door now opens with resistance and won't even stay completely opened unless the lower dishwasher tray is rolled out on it. it's like new.
This is the second repair to this dishwasher. Last year I replaced the door latch that had broken with a replacement purchased from partselect.com. That repair was also quite easy.
PartSelect's full part brochures by model made identifying the needed parts simple, and the replacement a breeze.
I even repaired my refrigerator ice maker a couple months ago after purchasing a new control module, and saving both a service fee and the probable full price for a new ice maker.
I've repaired my electric clothes dryer too, and hadn't even thought about all the repairs I'd done thanks to this website, until I told the story of my dishwasher.
I've probably saved $1000 already. Wow!
I love this site. Read more...

Videos!

Your Price

$13.17

Crosley Dishwasher Door Spring

★★★★★

3 Reviews

PartSelect Number PS11746856

Manufacturer Part Number WP912652

The door spring puts tension on the dishwasher door though the hinge. This keeps it from falling or dropping abruptly when opening and closing. Please note: The spring for either side of the door is sold individually. If you see that your dishwasher is leaking, the door will not close or open properly, or it gets stuck, then replacing the spring could be a solution to these symptoms. During installation, remember there is potential for the door spring to snap if it is under too much pressure. For safety precautions, make sure you unplug the dishwasher from the power source before beginning your project.

Fixes these symptoms

Door latch failure
Door won’t close
Leaking
See more...

Installation Instructions

kathleen from farmersville, CA

son used door for a step and bent as well as broke spring door component

first i removed the 2 holding screws fron the underside of the counter then oulled the dishwasher out about a foot. i then removed the side panel that hold the front plate in plase on the right, below this were the screws that held the door hinge assembly on the right. i then proceeded to remove those bolts. and replaced with the new one. replacing the spring and the linkage came next no tools required. i have to say that the diagram when i ordered helped emensly. i am a 45 yr old woman and fixed it by nyself thanks to your ordering diagrams. life is good!! Read more...

Videos!

Your Price

$31.04

Crosley Dishwasher Spring

★★★★★

6 Reviews

PartSelect Number PS11753142

Manufacturer Part Number WPW10337934

This door spring is a genuine OEM replacement part for your dishwasher. The spring ensures that your dishwasher door does not fall open too quickly. If this occurs, one or both springs should be replaced. This part consists of one spring. To replace the spring, you will need to pull the dishwasher about six inches to a foot out from the cabinet. Replacing the spring has been rated as an easy repair by our customers.

Fixes these symptoms

Door latch failure
Door won’t close
See more...

Installation Instructions

Reid from ALPHARETTA, GA

Dishes were not drying properly

Did the repair, but needed one extra step not described in video:

I followed the directions on the PartSelect Youtube video - very helpful! I do believe the heating element was the original culprit, as it had a "burn" area about the size of a dime that caused it to almost break into two parts. Obviously a point of failure.

BUT - after replacement, it still did not solve the problem of the dishes not drying.

After much web searching, I tried the diagnostic mode on the dishwasher, and that did a hard reset of the logic board and FIXED the problem.

So in all, it required both a new heating element AND a hard reset via diagnostic mode. Read more...

Videos!

Your Price

$7.95

Crosley Dishwasher Spring, Lid

★★★★★

12 Reviews

PartSelect Number PS11744874

Manufacturer Part Number WP8066018

The dishwasher lid spring helps open the dispenser cover in the soap box when the control releases the latch. If your dishwasher does not dispense detergent, is broken and worn out, or the door is not opening properly, replacing the dispenser spring could be the solution. For this replacement you will need needle nose pliers. First, release the cover on the detergent dispenser, then remove the cover from the shaft it hinges on. Pull the shaft from one side and remove the spring from the shaft. Next, replace with the new spring and engage the two open hooks into the soap cover. Finally, grasp the hook and pull it over tab on the side of the wash cup. Verify that it works properly by opening and closing the cap. Refer to the manual provided by the manufacturer for further instructions.

Fixes these symptoms

Door latch failure
Door won’t close
Not cleaning dishes properly
See more...

Installation Instructions

HAROLD from FISHERSVILLE, VA

Worn out spring on detergent release box lid

First, examine very carefully how the old spring relates to the detergent release box lid. Note that the top of the spring has a square-end upside down "U" . This rests on a small ledge on the detergent box. Also note that on either end of the spring is a straight extension of the spring wire. These two "legs" must rest on the inside of the edge of the detergent box. Second, use a flat blade screw driver to pry the LID hinge pin from the mounting "posts. Remove the pin, first noting the position of the spring. Reassemble the spring on the hinge pin in reverse order. Then snap the lid onto the spring using the two mounting "posts". NOTE: I used a very fine needle nose pliers to move the two spring "legs" behind the detergent box edge after I had mounted the lid. Flip the lid down to test if the spring pressure on the lid can be felt. Harold Kitzmann, Fishersville VA Read more...

Your Price

$12.75

Crosley Dishwasher Door Spring

★★★★★

1 Review

PartSelect Number PS11747686

Manufacturer Part Number WP99002598

Sold Individually.

Fixes these symptoms

Door latch failure
Door won’t close
See more...

Installation Instructions

jeffrey from holland, PA

broken door springs

I pulled the unit from under the counter. the springs and cables are on the front sides of the dishwasher. I moved the insulation removed the broken spring and cables and replaced them with the new parts. just one side was broken, but I replaced both while I had the unit out. Read more...

Videos!

Your Price

$26.86

Crosley Dishwasher Spring, Door

★★★★★

2 Reviews

PartSelect Number PS11741354

Manufacturer Part Number WP3379383

Installation Instructions

David from LEONARDTOWN, MD

broken door spring

Pulled dishwasher out from counter. Took cover off and replaced door springs. Read more...

Videos!

Your Price

$8.04

Crosley Dishwasher Door Spring

★★★★★

6 Reviews

PartSelect Number PS11741264

Manufacturer Part Number WP3368999

These detergent cup dispenser springs are sold individually.

Fixes these symptoms

Door latch failure
Not cleaning dishes properly
Will not dispense detergent
See more...

Installation Instructions

stephen from venice, FL

Detergent Cup does not open

Disconnect power supply to dishwasher. Open door and remove screws on inner door cover. Carefully remove inner cover while watching how inner parts are arranged. Found return spring on detergent cup linkage had rusted and broken causing detergent cup not to open. Installed new spring and re assembled inner cover. Rotated timer dial one full revolution to check operation of detergent cup. Worked like a charm. Re connect power supply to dishwasher and your good to go. Read more...