Crosley Dishwasher Caps and Lids

Videos!

Your Price

$7.27

Crosley Dishwasher Stop Clip

★★★★★

4 Reviews

PartSelect Number PS11770481

Manufacturer Part Number 5304506510

This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.

Installation Instructions

Bobby from Austin, TX

Broken wheels, Caps and Brackets. Couldn't hold dishes or wash right.

Just use a hexagonal driver to remove the Upper rack roller, screw the new ones in, place caps on the rail ends, and pop the new wheel on with some pliers! Simple and fun! Read more...

Videos!

Your Price

$19.93

Crosley Dishwasher Rinse Aid Cap

★★★★★

13 Reviews

PartSelect Number PS421128

Manufacturer Part Number 154388801

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Installation Instructions

Jeffrey from Mildland, MI

Striker

Removed the 4 screws that held the dishwasher in place, tilted it out, removed 2 nut screws on striker, installed new striker and put it back together. Very simple.

Thank you for stocking the parts and shipping them as promised. Read more...

Videos!

Your Price

$27.59

Crosley Dishwasher Rinse-Aid Dispenser Cap

★★★★★

46 Reviews

PartSelect Number PS11746426

Manufacturer Part Number WP8558307

The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.

Fixes these symptoms

Door latch failure
Leaking
Not cleaning dishes properly
See more...

Installation Instructions

James from Mesquite, TX

Cap came off and melted

Opened door and installed cap. Not much effort. But really got good service from Parts Select. Received order much faster than I had expected. Read more...

Videos!

Your Price

$11.10

Crosley Dishwasher Rinse Aid Cap

★★★★★

14 Reviews

PartSelect Number PS11741341

Manufacturer Part Number WP3378134

This cap does not require the use of an O-ring seal. The wet agent assembly cap is clear in color and made of plastic. This is a part for your dishwasher. This part may need to be replaced if you notice that your dishwasher is not dispensing detergent, cleaning dishes properly, or has sprung a leak. The cap is found on the inside of your dishwasher door. This is an extremely simple repair that requires no tools. Simply open your dishwasher door, twist the old cap out of place, ensuring no pieces are left behind. Screw your new cap into place.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Installation Instructions

Louis from Niceville, FL

Water dripped out from the bottom of door.

Diagnosing the problem, i.e. finding the source of the leak, was the hardest part. The best clue was the leak only occurred well into the cycle when the water was hot and steam was coming out the vent. I then assumed there was a bad seal and steam & condensed water was leaking down into the door. I replaced the vent duct & seal, a broken drip cover (an internal part in the door), and replaced a missing rinse aid cap. This stopped the leak. Read more...

Your Price

$16.48

Crosley Dishwasher Power Cord Junction Box Cover

PartSelect Number PS2363557

Manufacturer Part Number 154758501

Videos!

Your Price

$81.43

Crosley Dishwasher Protector

★★★★★

2 Reviews

PartSelect Number PS11746146

Manufacturer Part Number WP8531857

This part is used to cover the chopper blades.

Fixes these symptoms

Noisy
Not cleaning dishes properly
See more...

Installation Instructions

Patty from Caldwell, ID

Dishwasher leaving food residue on all dishes

Had to take apart dishwasher and replace chopper assembly. The dishwasher had a lot of debris in in including pieces of broken plastic forks. Now works great Read more...

Your Price

$7.59

Crosley Dishwasher Door Vent Screen

PartSelect Number PS11741302

Manufacturer Part Number WP3371710

Fixes these symptoms

Leaking
See more...

Installation Instructions

mary from Fountain Green, UT

leaking water

The first thing I did was to investigate. I needed to find where the leak was coming from. It was leaking from just above tne door front panel, directly underneath the control panel buttons. I opened the dishwasher door, and decided to remove the door screen vent. I was covered with some offwhite fiberous, or filter like material. I thought perhaps the filter had broken down, and I ordered a new screen. When it arrived, and, although I had expected to receive a new filter with the plastic door screen, I didn't. There wasn't one to be ordered. I looked at the screen again. My problem was, that although I had considered that the substance I had thought was a filter, was instead build up of detergent, and other particals. That idea didn't seem to make sense. I didn't think it was possible for that stuff to get to the door screen. I thought, it was too far away from the dispenser and food particles. As it turned out, the buildup was, in fact, the problem. I properly cleaned the door vent, which was then fine, and I put it back into the door. There were no more leaks, that was it, and the problem was solved. As a last note however, unfortunatley, I have to return the new door vent screen that I ordered. I enjoyed solving the problem, and you all helped alot. Let's do it again sometime. Read more...