KitchenAid Dishwasher Wire Plugs and Connectors

Your Price

$13.55

KitchenAid Dishwasher Wire Harness

PartSelect Number PS11750079

Manufacturer Part Number WPW10195666

This wire harness is for dishwashers and supplies power to electrical components in the dishwasher.

Your Price

$22.86

KitchenAid Dishwasher CONNECTOR

PartSelect Number PS11703328

Manufacturer Part Number W10783730

Your Price

$174.29

KitchenAid Dishwasher Wiring Harness

PartSelect Number PS11754429

Manufacturer Part Number WPW10413098

Your Price

$130.92

KitchenAid Dishwasher HARNS-WIRE

PartSelect Number PS11769018

Manufacturer Part Number W10871222

Your Price

$163.97

KitchenAid Dishwasher HARNS-WIRE

PartSelect Number PS11738102

Manufacturer Part Number W10871221

Your Price

$146.69

KitchenAid Dishwasher Ribbon Cable

★★★★★

1 Review

PartSelect Number PS11746082

Manufacturer Part Number WP8524447

This part is used to connect the electronic control board and the touchpad control board.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Norman from Weatherford, TX

Dishwasher would not start when Normal was selected. Would run fine if other option selected.

I began by opening the door to the dishwasher. The front panel on this unit is a custom wood panel held on by six screws. I removed the screws and the front panel. Then I unscrewed the two remaining screws holding the control panel onto the door. I also removed the two screws holding the door latch in position. With all screws removed the control panel simply slid off the top of the door. Inside the control panel, I used a small screw drive to pry the retainer clips back from the edge of the electronic control board. The control panel then snaps out. I disconnected the ribbon cable from both boards and reinstalled the new ribbon cable. I then reattached the ribbon cable to the new electronic control board and snapped the new control board into place. I reinstalled the control panel and tested the "Normal" position to insure the dishwasher would respond appropriately. After checking for proper operation, I reinstalled all screws,including the door latch and the front cover. Operation complete. Read more...