KitchenAid Range Circuit Boards and Touch Pads

Your Price

$250.55

KitchenAid Range Membrane Switch - Stainless Steel

★★★★★

1 Review

PartSelect Number PS11747180

Manufacturer Part Number WP9756559ES

Also known as the touch pad. This part does not include the main control board.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

Jeffrey from Vicksburg, MS

function key stuck

The repair was easy, I used one screw driver and that was it, less than an hour. Part worked great! Before I repaired the oven, I was told by a service tech. the repairs would cost $693, I repaired myself for $166 tnru part select . Using a Philips head driver I unscrewed two screws holding the front panel onto the stove, unplugged the control panel. Unscrewed the mother board pulled old membrane switch out replaced it with new. Its that easy. Then reverse the process. Read more...

Videos!

Your Price

$254.24

KitchenAid Range Switch Membrane

★★★★★

5 Reviews

PartSelect Number PS11747185

Manufacturer Part Number WP9756595ES

Also known as touchpad or overlay. The colour is Etched Stainless.

Fixes these symptoms

Touchpad does not respond
See more...

Your Price

$80.76

KitchenAid Range Noise Suppressor

PartSelect Number PS11742574

Manufacturer Part Number WP4451985

This part controls the voltage and helps to reduce interference on the control board

Your Price

$155.64

KitchenAid Range Display Module - Black

PartSelect Number PS11742595

Manufacturer Part Number WP4452999

Your Price

$563.16

KitchenAid Range Spark Module

★★★★★

4 Reviews

PartSelect Number PS11753037

Manufacturer Part Number WPW10331686

This is the part that substitutes for the spark module and also the transformer. It is now all in one board.

Fixes these symptoms

Little to no heat when baking
Will Not Start
See more...

Installation Instructions

HERBERT from ISELIN, NJ

stove will not start no spark or gas

part did not fix the problem, may be gas regulater ,well if you are changing this part,not to bad .remove the knobs bottom screws and two side screws front cover flips up and off ,the ignition control is in front of you right side ,remove the one screw that is looking at and everything slides out .i turned off the gas and elec and removed the gas line and carefully laid the stove on it back.made it easier ,good luck Read more...