Kenmore Washer Dryer Combo Wheels and Rollers

Videos!

Your Price

$22.69

Kenmore Washer Dryer Combo Dryer Drum Support Roller

★★★★★

38 Reviews

PartSelect Number PS11752609

Manufacturer Part Number WPW10314173

This drum support roller is sold individually. Most dryers require two. The tri-rings are included. This is a drum support roller for a dryer. It is a genuine replacement part. The part includes the drum roller only and does not include the tri-rings. This part is sold separately. Most dryers require two drum rollers. It is recommended to check and replace both drum support rollers at the same time to ensure proper drum rotation and because they often wear at the same rate. The drum support roller holds the drum in the proper position while it spins on the support wheels. If rollers are worn out, they will cause the dryer to be noisy.

Fixes these symptoms

Marks left on clothes
Noisy
See more...

Installation Instructions

Jeff from Phoenix, AZ

noisy and slow drum speed

1. disconnect power,gas and vent lines
2. pop off top of unit
3. remove front of dryer
4. lay unit on its back
5. remove drum and replace pulley assembly,belt,drum rollers of which it has 2 rear and 2 front
6. reverse above and then remove filter-vent housing and scrape off old seal install new seal
7. re-connect power,gas and vent use again
8. only sad part to whole job was seeing how cheaply whirlpool now makes thier products Read more...

Videos!

Your Price

$14.37

Kenmore Washer Dryer Combo Rear Drum Support Roller Kit

★★★★★

118 Reviews

PartSelect Number PS347627

Manufacturer Part Number 349241T

The drum support roller kit allows the dryer to tumble properly by supporting the drum cylinder. The kit includes two drum rollers, four tri-rings, and one palnut (or retaining washer). The kit does not include a belt or idler pulley and rollers are not sold individually. The drum support roller kit may need to be replaced if the dryer is noisy or will not tumble. The tools needed to complete this repair are a putty knife, Phillips screw driver, and a 5/16 nut driver. This is an OEM part sourced directly from the manufacturer.

Fixes these symptoms

Drum Not Spinning
Marks left on clothes
Noisy
See more...

Installation Instructions

Mark from Fremont, NE

Wife told me Dryer would make a funny sound, then stop + had an a funny smell as well. The Electric motor that drove the unit was overheating and locking up, It was time to be replace.

The best part of my repair was I had everything back in service in 3 days. And one of these days was to consider just buying a new dryer. Had parts overnited and all parts fit and easy to replace.

1) Removed back - 6 screws
2) Removed dryer vent - 2 screws on top, 3 on bottom
3) Popped the top open
4) Removed Front of dryer cabinet - 2 screws
5) Removed Belt
6) Removed Drum
7) Cleaned up all lint
8) Pop off motor retainers front and back
Here is the tricky part for me.
9) Removed vent fan on back of motor.
I did not know that the back of the fan was square, and you could put an open ended wrench on it to hold it while you also have a vice grip on the front motor shaft. Then its a simple left to loosey operation. I first tryed to turn the fan blade to take it off, but proved to be to tight.
10) Repeat backwards to reassemble

While I had it apart I also replaced the Drum support rollers & Installed a new belt. Not that diffucult of a repair Good Luck, was certainly better than buying a new one at + $300.00 at Black Friday rates. Read more...

Videos!

Your Price

$26.95

Kenmore Washer Dryer Combo Idler Pulley

★★★★★

117 Reviews

PartSelect Number PS334244

Manufacturer Part Number 279640

This Idler Pulley includes the tri-ring and gasket and everything included here is manufacturer-certified. This part maintains correct tension on the drive belt in order to spin the drum properly. If damaged or broken the dryer will not dry properly, will not tumble properly, or may not even start. Installation is rated as "Medium" difficulty. This part is located on the dryer drum, around the tension pulley. Refer to your user manual and model number for repair instructions and to ensure this part is right for you. For this repair project, the tools needed are a Phillips screwdriver, 1/4 inch nut driver, putty knife, small flat blade screw driver, and needle nose pliers.

Fixes these symptoms

Drum Not Spinning
Noisy
See more...

Installation Instructions

eric from Boulder, CO

Belt Wheel was broken at axle. Terrible noise.

Removed the top and back of dryer with screw socket. It was quite easy. Then, I removed the broken wheel by releasing the tension spring. I replaced the wheel. The toughest part was re-threading the belt. But, even that was simple. The dryer runs smoothly and quietly again! Read more...

Videos!

Your Price

$64.43

Kenmore Washer Dryer Combo Drum Roller Shaft - Left Side

★★★★★

4 Reviews

PartSelect Number PS11753706

Manufacturer Part Number WPW10359270

Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Edward from Andover, NJ

Dryer was sqeaking loudly when running

I Looked on internet sites for this type of problem.
Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.

Edward Brennan Read more...

Videos!

Your Price

$52.73

Kenmore Washer Dryer Combo Drum Support Shaft - Rear Shaft with Right Hand Threads

★★★★★

2 Reviews

PartSelect Number PS11753708

Manufacturer Part Number WPW10359272

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Fixes these symptoms

Noisy
See more...

Installation Instructions

John from Tucson, AZ

worn out part

The repair was fairly easy. The most timely part of the repair was removing the twelve screws from the back panel to expose the repair. Read more...

Videos!

Your Price

$59.02

Kenmore Washer Dryer Combo Drum Support Roller Shaft - Right Hand Threads

★★★★★

1 Review

PartSelect Number PS11753707

Manufacturer Part Number WPW10359271

This front shaft with right hand threads is used in dryers. The shaft and the drum support rollers ride on to support the drum. If your shaft has flat spots and the rollers do not spin, replacing the shaft can solve the problem. The tools needed for this repair are: 5/16 inch socket or nut driver, 1/4 inch socket or nut driver, small flathead screw driver, channel-lock pliers, 9/16 inch socket. Remember to unplug your appliance from the power source before beginning this installation project. Refer to the diagram provided by the manufacturer for further installation instructions.

Fixes these symptoms

Noisy
See more...

Installation Instructions

rodney from Mad River, CA

parts took more than two months to get here.

I'm still waiting on my idler pulley. It arrived at Fed EX depot in Tracy CA on December 14th and has still not been shipped. So it is pretty fucking hard for me to install it! Maybe if you had customer service that would answer their phones or reply to my Emails would be helpful Read more...

Videos!

Your Price

$62.32

Kenmore Washer Dryer Combo Drum Support Roller Shaft - Right Side

PartSelect Number PS11753705

Manufacturer Part Number WPW10359269

Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Edward from Andover, NJ

Dryer was sqeaking loudly when running

I Looked on internet sites for this type of problem.
Most sites said the support rollers could cause this.
I found your site PartSelect and with help of your diagrams of the machine ordered the parts I thought were needed plus other parts that might cause the problem.
With machine torn down I replaced the rollers.
I had also ordered the main drive belt and idler assembly with the rollers and these also needed replacement. It is a good idea to order other suspect parts when doing this type of repair since you can return the parts not needed.
Your return policy is great.

Edward Brennan Read more...

Your Price

$66.76

Kenmore Washer Dryer Combo Blower Wheel

★★★★★

3 Reviews

PartSelect Number PS417911

Manufacturer Part Number 131476300

This blower wheel is a genuine OEM replacement part for your dryer. The wheel can become damaged through use of the dryer, especially if the drive motor shaft, which it is attached to, becomes damaged. This repair will require some disassembly of the dryer. Make sure to disconnect the power source and wear appropriate work gloves while conducting this repair.

Fixes these symptoms

Noisy
See more...

Installation Instructions

Jeffrey from Gulf Breeze, FL

dryer squeeked and rattled

after removing the panel covering the dryer blower and removing the blower cover, i pulled the old blower wheel off and placed the new whell on carefully lining the flat edge of the wheel hole up with the flat edge on the blower piston, the n i placed the clamp on and put back all the housing covers and panels...and now my dryer runs quiet and drys cloths fast....thanks to partselect!!!! Read more...