Official Electrolux Washer Parts

Your Price

$20.46

Electrolux Washer LATCH

★★★★★

8 Reviews

PartSelect Number PS11766033

Manufacturer Part Number 5304505088

Fixes these symptoms

Lid or door won’t close
Locking Issues
Will Not Start
See more...

Installation Instructions

Kim from LAFAYETTE, CA

latch broke, door wouldn't shut, washer wouldn't run - no fun

I googled the problem, read the recommendation found the part and read that it was an easy fix. Took the broken part off the door and noticed the broke off piece was in the latch on the machine. Ordered the two parts, paid the $30 2-day delivery. Parts arrived and the machine was up and runnning in under 5 minutes Read more...

Your Price

$106.20

Electrolux Washer Bellow

★★★★★

6 Reviews

PartSelect Number PS12731388

Manufacturer Part Number 5304505004

Fixes these symptoms

Leaking
See more...

Videos!

Your Price

$20.16

Electrolux Washer Door Striker

★★★★★

18 Reviews

PartSelect Number PS2378364

Manufacturer Part Number 131763302

This is a door striker, it is gray in color and is a part found on your washer. The purpose of the striker is to keep your washer door closed for usage. This piece will attach to your appliance lid and will activate the door switch when your lid is closed. The most common reasons for needing to replace this part are if your lid will not consistently open or close, and your washer will not consistently start. The only tool you will need to complete this installation is a Phillips screwdriver.

Fixes these symptoms

Door won’t close
Lid or door won’t close
Locking Issues
See more...

Installation Instructions

Paul from Grinnell, IA

Door Striker broke which was a result of the hinge problem.

Removed the screws holding the door. (One was stuck a little so used an air drill with Phillips head to get the torque needed but someone with a strong grip could have done it as it came out very easily). I removed most of the screws holding the front to back of door to exchange the hinge. There was a problem with the old hinge slopping around and not allowing the door to align properly when shutting it. The new hinge works better. See note*** below on doorframe. I pretty much was able to get the door back together and make it work. I then exchanged the door striker with no problem. It has a built in key so you cannot attach it incorrectly. The next thing was to just reattach the door to the machine and it worked right off the bat. ------------- *** Unfortunately, there were two screw mounts in the Outer Door Frame - Chrome Part Number: PS3495258 that were broken. This doorframe is listed as a $200+ chrome part whereas it is actually a plastic material that is extremely over priced for what it is. Like I mentioned two of the screw mounts had broken off so those screws are just "decoration" now. (These are screws that basically hold the back cover to the front cover). If this becomes a problem, I will simply modify what I have and make the screws fit before I spend $200+ on that part. (It looks like this could be drilled out and a long screw and nut run through to make it work. TELL THE WASHER OPERATOR… just be careful opening and closing the unit (don't slam the door but carefully close it) and it should work a lot longer. I might investigate the make up of a washer the next time I buy one … but the chrome vs. plastic is a hard one to spot. I hope this helps. Read more...

Your Price

$90.85

Electrolux Washer DOOR LOCK

★★★★★

1 Review

PartSelect Number PS12365826

Manufacturer Part Number 5304514774

Fixes these symptoms

Lid or door won’t close
Locking Issues
Will Not Start
See more...

Installation Instructions

Kim from LAFAYETTE, CA

latch broke, door wouldn't shut, washer wouldn't run - no fun

I googled the problem, read the recommendation found the part and read that it was an easy fix. Took the broken part off the door and noticed the broke off piece was in the latch on the machine. Ordered the two parts, paid the $30 2-day delivery. Parts arrived and the machine was up and runnning in under 5 minutes Read more...

Videos!

Front Load Washer Door Lock and Switch Assembly – Part Number: 131763256

Your Price

$127.91

Electrolux Washer Front Load Door Lock and Switch Assembly

★★★★★

30 Reviews

PartSelect Number PS12364048

Manufacturer Part Number 131763256

This door lock and switch assembly is manufactured to lock the door on your front load washer to prevent it from opening while it is running. You may need to replace the door lock and switch if the door does not open or lock. Your washer will not start if the door does not lock. This part is also known as a washing machine door lock assembly. As per the manufacturer, some models require a new wire harness and a door strike for this door lock assembly to work on the appliance. The original style lock would require the door lock kit.

Fixes these symptoms

Leaking
Lid or door won’t close
Locking Issues
See more...

Installation Instructions

DOUG from KING FERRY, NY

Door on washer wouldn't lock or start

1. Unplug unit.
2. Unscrew 2 nuts holding top in place in rear of unit using phillips head screwdriver.
3.Slide top back and remove.
4. Open door of washer and unscrew 2 screws holding in door lock unit.
5.Pull out unit from the top and install new unit reconnecting the 3 wire connections. Read more...

Videos!

Shock Absorber Kit – Part Number: 5304485917

Your Price

$39.67

Electrolux Washer Shock Absorber Kit

★★★★★

22 Reviews

PartSelect Number PS3508101

Manufacturer Part Number 5304485917

This shock absorber kit is an authentic OEM part that is sourced directly from the manufacturer. The kit includes two dual-stage shock absorbers, one spare shock mounting pin, and four locking nuts. These shock absorbers keep your front-load washer from shaking vigorously by absorbing and reducing vibrations from the wash and spin cycles of your appliance. This kit comes with two shock absorbers because it is recommended to replace both at the same time, as they wear at the same rate. To access your washer shock absorbers, simply remove the lower access panel after disconnecting the power to the appliance.

Fixes these symptoms

Leaking
Noisy
Shaking and Moving
See more...

Installation Instructions

Douglas from Medical Lake, WA

Both vibration shock absorbers broken

removed 2 screws and removed top access cover. removed 2 screws and removed front access cover. removed 4 retaining pins (one with nammer and punch because it was stuck) connected lower ends of new shocks with plastic pins, extended each shock to slip fit and connected upper ends to wash tub mounts. Reinstalled panels. I wish I could say that it all went well from there but......when the shocks broke, apparently the hit the motor took was enough to cause an electronic failure of the speed cycle control chip. Now Im waiting for that part. Read more...

Your Price

$60.30

Electrolux Washer Door Strike

★★★★★

11 Reviews

PartSelect Number PS2345126

Manufacturer Part Number 134937300

The door strike is used in washers and is attached to the door to activate the switch when the door is closed. This ensures that the washer door remains locked and closed. If your door does not stay open, or it gets stuck, replacing this part can solve the problem. This part comes in a gray color and is made from metal. This door strike is a genuine replacement part. As a safety precaution remember to unplug your washer from the power source and wear work gloves before installing this part. Refer to the diagram provided by the manufacturer for more installation instructions and guidance.

Fixes these symptoms

Lid or door won’t close
Locking Issues
See more...

Installation Instructions

Paul from DAYTON, OH

Broken door latch

First, I went to the PartSelect website and easily found the part at a reasonable price. I ordered it early on a Wednesday afternoon, and gladly spent the extra $25 to ship it overnight. That evening, PartSelect sent me an email stating that the part had shipped that very day, and - mistakenly - I took that literally. FedEx tracking predicted that the part would arrive on Friday, July 5, which made sense because the 4th was a holiday.
But I found out that the part had actually shipped on the 3rd, as the email had informed me. It didn't actually ship until the 4th - up until then, a "shipping label" had been created but it had not shipped. FedEx then revised their arrival date to Monday, 8 July.
That clearly wasn't satisfactory. So I went to my local parts distributor, Dayton Appliance Parts, a fifteen-minute drive from my house, and got the same part for $3 cheaper, plus without the $25 shipping fee that PartSelect had charged me for overnight-shipping-that-isn't-actually-overnight-shipping.
Once I had the part in hand, installation was a breeze. Two screws removed, pulled the striker, replaced the new part and the screws. Less than two minutes.
But no thanks to PartSelect. Read more...

Videos!

Your Price

$24.93

Electrolux Washer Drive V-Belt

★★★★★

28 Reviews

PartSelect Number PS1146950

Manufacturer Part Number 134511600

This rubber V-style drive belt slips on the motor pulley to bring the basket to the required speed. If you notice a burning rubber smell or grinding noises coming from your washer, your washer does not start, drain, spin properly (will not spin/spins slowly/will not agitate properly), or if your washer shakes or moves during the cycle; check your drive belt for signs of wear and tear. Replace the drive belt if you notice that the belt looks damaged. This OEM part is approximately 35 inches in length, and sold individually.

Fixes these symptoms

Burning smell
Noisy
Spinning Issues
See more...

Installation Instructions

rodney from fairfield bay, AR

replace broken drive belt

carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run belt on,release tension on idler arm.replace front panel and lower top.WALAAH!!!! you are done. Read more...

Videos!

Drain Pump - 120V 60 Hz. – Part Number: 137221600

Your Price

$165.56

Electrolux Washer Drain Pump - 120V 60 Hz.

★★★★★

23 Reviews

PartSelect Number PS7783938

Manufacturer Part Number 137221600

This is a 120 volt, 60 hertz drain pump that is manufactured to remove water from the tub of your washer once your clothes are washed. This part is the pump and motor assembly, which includes a red flapper to prevent drain backflow. You will need to remove the front panel of your washer to access the drain pump. The tools you will need for the repair are a Phillips screw driver, a putty knife, a pair of slip joint pliers, and a 5/16 nut driver. Be sure to disconnect the water supply from your washer before doing the repair. The metal edges on the appliance are sharp, so use work gloves to safely complete the repair.

Fixes these symptoms

Leaking
Not draining
Will not drain
See more...

Installation Instructions

kenneth from willard, OH

would't spin all water out or rinse out clothes

uplugged washer took front off washer 2 screws pryed up top pump was mounted with 2 screws and 2 wires took off found change in pump and the fins to pump worn off ordered part off line the wait for part was longer than the amount of time to fix problem and cost of part saved me about $25-35 if I was to buy local worth wait save money and fix problem washes like new spins and drains all water from tub. Read more...