Dishwasher Wire Plugs and Connectors
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Dishwasher Wire Plugs and Connectors
Your Price
$28.12
In Stock
Your Price
$13.55
Special Order
Dishwasher Wire Harness
PartSelect Number PS11750079
Manufacturer Part Number WPW10195666
This wire harness is for dishwashers and supplies power to electrical components in the dishwasher.
Your Price
$14.36
In Stock
Dishwasher Wire Harness
PartSelect Number PS11770295
Manufacturer Part Number W11028004
This wire harness is for dishwashers and supplies power to electrical components in the dishwasher.
Your Price
$22.86
In Stock
Your Price
$174.29
Special Order
Your Price
$130.92
On Order
Your Price
$38.72
In Stock
Your Price
$17.23
In Stock
Dishwasher Turbidity Sensor Wire Harness
PartSelect Number PS3495367
Manufacturer Part Number 154833101
Your Price
$163.97
In Stock
Your Price
$146.69
In Stock
Dishwasher Ribbon Cable
PartSelect Number PS11746082
Manufacturer Part Number WP8524447
This part is used to connect the electronic control board and the touchpad control board.
Fixes these symptoms
- Will Not Start
- See more...
Installation Instructions
Norman from Weatherford, TX
Dishwasher would not start when Normal was selected. Would run fine if other option selected.
I began by opening the door to the dishwasher. The front panel on this unit is a custom wood panel held on by six screws. I removed the screws and the front panel. Then I unscrewed the two remaining screws holding the control panel onto the door. I also removed the two screws holding the door latch in position. With all screws removed the control panel simply slid off the top of the door. Inside the control panel, I used a small screw drive to pry the retainer clips back from the edge of the electronic control board. The control panel then snaps out. I disconnected the ribbon cable from both boards and reinstalled the new ribbon cable. I then reattached the ribbon cable to the new electronic control board and snapped the new control board into place. I reinstalled the control panel and tested the "Normal" position to insure the dishwasher would respond appropriately. After checking for proper operation, I reinstalled all screws,including the door latch and the front cover. Operation complete.
Read more...
