Crosley Washer Circuit Boards and Touch Pads

Your Price

$208.02

Crosley Washer Electronic Control Board

PartSelect Number PS12724037

Manufacturer Part Number 137005000NH

The electronic control board manages the washer's functions such as filling, washing, draining and spinning.

Fixes these symptoms

Will Not Start
See more...

Videos!

Your Price

$240.13

Crosley Washer Timer - 60 Hz.

★★★★★

1 Review

PartSelect Number PS11746742

Manufacturer Part Number WP8577356

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Fixes these symptoms

Will Not Start
See more...

Your Price

$273.84

Crosley Washer Motor Control Board

PartSelect Number PS10066118

Manufacturer Part Number 134618213

Installation Instructions

Baruch from HURLEYVILLE, NY

washer stops in middle of cycle and E53 appears on the screen

1 you have to order a new motor control board
2 unscrew the back panel
3 unscrew the top panel
4 unscrew the bracket
5disconnect the old motor control board
6 connect the new motor control board Read more...

Your Price

$210.54

Crosley Washer Timer

★★★★★

4 Reviews

PartSelect Number PS11742012

Manufacturer Part Number WP3948357

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Installation Instructions

Michael from Coeur d'Alene, ID

Washer stops on 1st spin/drain cycle

Unscrew timer/main control knob, then remove 2 spacers behind the knob. Remove 2 main control panel screws at each front lower corner. Rock panel back (pull slightly forward before rocking back to release plastic notches) to expose wire harness and timer. Remove 2 screws holding timer and disconnect timer electrical connector. Put new timer on with screws and attach connector correctly. Rock panel forward into place and reattach panel screws, spacers and knob. Note: Make sure lid switch is working properly before assuming the timer is bad. My switch is also intermittent and needed a shim on lid male plastic piece to engage the switch plate. Read more...

Videos!

Your Price

$205.28

Crosley Washer Control Timer

★★★★★

4 Reviews

PartSelect Number PS11742046

Manufacturer Part Number WP3951702

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.(60 Hz.)

Fixes these symptoms

Will not drain
See more...

Installation Instructions

michael from deersville, OH

washer would'nt cycle

remove two screws that hold down top piece that holds timer. [screws are at each end] pull the top peice foward[ toward front of washer] just about 1 inch,then flip it up so you can see back of timer,pull out black tab that holds timer knob [with the tweesers],remove knob and dial unplug the wiring remove the screw under timer knob raise clip on the side of timer so it will slide toward left side remove timer. reverse instructions to install. PS VERY IMPORTANT!!!!!MAKE SURE TO UNPLUG WASHER FIRST!!!!!!!!!!!!!!!!!!! Read more...

Your Price

$254.34

Crosley Washer Timer, Control (60 Hz.) (Motor

★★★★★

3 Reviews

PartSelect Number PS11746373

Manufacturer Part Number WP8546685

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Your Price

$217.89

Crosley Washer Control Timer

★★★★★

1 Review

PartSelect Number PS11750181

Manufacturer Part Number WPW10199989

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Installation Instructions

SHAWN from Philadelphia, PA

washer not cycling or working on all cycles.

On my model You have to first lift the control panel in order to remove timer knob.I removed control panel by prying on the ends of panel one at a time with putty knife and rag to keep from scratching washer. I then use needle nose pliers to pull plastic under side of knob while pulling on knob which is the trickiest part of the job as knob will not come of til it is pulled from underside with needle nose pliers to release it then its easy from that point to disconnect wires and slide timer to the left to unlock it and in stall new timer.You have to take your time doing the repair and it will work out better for you.After replacing timer machine works on all cycles and completes entire cycle. Thank You PartSelect! Read more...

Videos!

Your Price

$60.10

Crosley Washer Noise Filter - 275V and 50/60Hz

PartSelect Number PS11753813

Manufacturer Part Number WPW10367632

Fixes these symptoms

Will Not Start
See more...

Your Price

$239.26

Crosley Washer Timer - 60Hz

PartSelect Number PS11742079

Manufacturer Part Number WP3954563

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

Installation Instructions

Peter from Syracuse, NY

Problem with cycles stopping at the wrong point, problems with water temp.

The video for the water inlet valve/solenoid is excellent to show you how to get the top off so you can get to the timer. Then just two tips:

1) when you pull the existing knob off the front per the instructions on the new timer, there is a small screw on the face of the top unit, next to the timer spindle, that must be removed - otherwise the timer won't slide out from under the tabs. Then, looking at the existing timer from behind, there is a thin tab on the left that needs to be lifted up about 1/8", which will allow you to slide the timer unit to the left about 1/4" to get out from the 3 other tabs, and lift it out.

2) be very careful to line up the timing marks for the timer (old and new) and the knob markings, otherwise the cycle text on the actual face of the top unit won't line up correctly with what the knob is pointing to, and nothing will seem to work right!

Ultimately, for us, the problem ended up being the water intake valve, but I think the above will help anyone with a timer issue. Read more...