Westinghouse Washer Dryer Combo Switches

Your Price

$82.69

Westinghouse Washer Dryer Combo Water Level Switch

PartSelect Number PS1146954

Manufacturer Part Number 134422700

Installation Instructions

Aaron from Williamson, WV

Leaking washing machine; water would not shut off on fill up and rinse

Replacing the switch is relatively easy, however, I would caution all experiencing similar problems one thing. Before assuming, as I did, that the switch was bad, first remove the panel of the washer that houses the washing tub/basin. On the back of the tub, check to make sure that the tube connecting the tub and switch has not come off from the tub as it did in my situation. The solution to my problem of a leaking washing machine where the water would not stop filling on both wash and rinse cycles was simply reattaching the tube to the tub. If I would have checked that first, total job completion time would have been under 15 minutes. Hope this helps. If you need to replace the actual switch, remove the knobs, screws, and panel. Remove the wires, tube, and screw from the switch and reassemble new switch. That took me about 30-45 minutes. Read more...

Your Price

$61.83

Westinghouse Washer Dryer Combo Start Switch

★★★★★

4 Reviews

PartSelect Number PS1146154

Manufacturer Part Number 134399700

This start switch is a manufacturer-approved replacement part for your dryer. A faulty start switch means your dryer will not begin its drying cycle. In order to complete this repair, you will need a Phillips screwdriver. Once you access the switch, disconnect the two wire leads and attach them to the new switch. Make sure to disconnect power to the unit before beginning this repair, and wear work gloves.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Greg from Lampasas, TX

Knob craked and broke off the start switch

Removed all the knobs but the master washing machine control knob, then the control and cover panels by removing the two screws that held each one. Then removed the end plastic pieces to allow access to screws holding the switch onto control panel. Used pliers to pull wires off the old switch and put them back on new switch. Screwed it back in place and re-attached plastic end pieces. Re-attached the control panel, then the cover panel under the control panel. Read more...