Snapper Lawn Tractor Seals and Gaskets

Your Price

$7.88

Snapper Lawn Tractor Seal--Oil (PTO Side)

★★★★★

2 Reviews

PartSelect Number PS9151828

Manufacturer Part Number 795387

This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty as Medium. This part provides a seal around the crank shaft and engine block. When installing onto the engine block around the crank shaft, use something that makes contact around the entire seal, like a large socket or pipe, and tap into place evenly, ensuring that the housing is clean and dry. If the part is broken, likely due to fatigue, there will be leaking oil, and this part should be replaced using the model number on the original part to confirm it is the right fit for your model.

Installation Instructions

rodney from MUSCATINE, IA

governor not working

Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions Read more...

Your Price

$7.65

Snapper Lawn Tractor Gasket-Rocker Cover

★★★★★

1 Review

PartSelect Number PS9062980

Manufacturer Part Number 690971

Your Price

$6.59

Snapper Lawn Tractor Seal,Oil

★★★★★

1 Review

PartSelect Number PS9277860

Manufacturer Part Number 391086S

The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "Medium" difficulty and requires a screw driver, wrench set and seal puller. A broken seal will cause a leak, and the part must be replaced. Refer to your make, model and diagram to ensure you're choosing the right part. This part comes in black and gray.

Your Price

$6.25

Snapper Lawn Tractor Gasket, Foam

PartSelect Number PS9902311

Manufacturer Part Number 1707335SM

Your Price

$26.91

Snapper Lawn Tractor Gasket-CylinderHead

PartSelect Number PS9067184

Manufacturer Part Number 693997

This is a replacement cylinder head gasket for your small engine. The gasket is approximately 5 inches in length and 5 inches in width at its longest and widest points. The gasket creates a seal, and the seal allows combustion to occur, making your engine run at peak performance. If the gasket is damaged or coming apart, you may notice a decrease in the power and performance of your engine. When you remove the old gasket, be sure that the surface you are attaching the new one to is completely clean, so the seal will be effective. This part is sold individually and it is a genuine OEM part.

Installation Instructions

george from HALLWOOD, VA

valve problem causing pushrod damage

pinged valve guide reinstalled head with new gasket inserted rods adjusted valve 15 min. later mowing lawn first time doin such repair note used magnet to pull old rod inside engine to drain left in rotated engine maling sure no parts broken started up and away i went c how long it lasts mower had over6500 hrs.. on it Read more...

Your Price

$5.34

Snapper Lawn Tractor Gasket-Exhaust

PartSelect Number PS9063564

Manufacturer Part Number 690970

Installation Instructions

george from HALLWOOD, VA

valve problem causing pushrod damage

pinged valve guide reinstalled head with new gasket inserted rods adjusted valve 15 min. later mowing lawn first time doin such repair note used magnet to pull old rod inside engine to drain left in rotated engine maling sure no parts broken started up and away i went c how long it lasts mower had over6500 hrs.. on it Read more...

Your Price

$4.99

Snapper Lawn Tractor Seal-O Ring

★★★★★

1 Review

PartSelect Number PS9294749

Manufacturer Part Number 691917

The Seal-O Ring, also known as the gasket, is red in color, made of rubber, and is an OEM part that requires some skill to replace. This part is designed to create a seal between the carburator and manifold, to prevent air from entering. If your engine loses power, creates a hissing noise, or if the gasket appears damaged or your engine running improperly it may be time to replace the part. If you run the engine and spray the outside of the carburator with soapy water, you can test whether or not the gasket is leaking by listening to the sounds produced. If the sound smooths out then you've found your leaky gasket. Damage may occur over time, especially if the part dries out, and make the part appear stretched or worn out. When making this medium-difficulty repair, make sure the new gasket is fitted properly between the carburetor and intake manifold.

Installation Instructions

FRANK from EASTANOLLEE, GA

Screw can out of the carburator throttle baffel and stuck in the exhaust valve

No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!! Read more...

Your Price

$3.99

Snapper Lawn Tractor Plug

PartSelect Number PS9081222

Manufacturer Part Number 7011024YP

This OEM plug is sold individually and measures just over an inch in diameter. It attaches to the case cove of your equipment, is black in color, made of plastic and will need to be replaced when the old plug is dry out, cracking, or generally showing signs of wear. You may observe grease leaking out if this part needs replacing. Dirt can also get into the case if it is cracked, and cause problems over time such as a grinding noise. This is a somewhat challenging repair that requires a screwdriver, pliers, and a wrench.