Murray Lawn Tractor Seals and Gaskets
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Murray Lawn Tractor Seals and Gaskets
Your Price
$7.88
On Order
Murray Lawn Tractor Seal--Oil (PTO Side)
PartSelect Number PS9151828
Manufacturer Part Number 795387
This OEM Seal-Oil (PTO Side), also called the Oil Seal, is a Black, Nitrile Rubber, 2/14 O.D., individually sold part which is installed using a Seal Puller. Customers rate the installation difficulty as Medium.
This part provides a seal around the crank shaft and engine block. When installing onto the engine block around the crank shaft, use something that makes contact around the entire seal, like a large socket or pipe, and tap into place evenly, ensuring that the housing is clean and dry. If the part is broken, likely due to fatigue, there will be leaking oil, and this part should be replaced using the model number on the original part to confirm it is the right fit for your model.
Installation Instructions
rodney from MUSCATINE, IA
governor not working
Had to pull the engine off the rider mower. Drained the oil took shield off the flywheel. Set it upside down on a 5 gal bucket. Took a 7/16 hand wrench to remove governor lever from bottom of engine. Left it in its location. Pulled 10 1/2 " bolts. Split engine case. Found the old governor had broke into pieces. Had to use a magnet to remove all the pieces. Removed the small clip and removed gear. Lubed shaft slid new on put new clip on. Lined governor weights with center piece tapped it in place very lightly. Cleaned gasket flanges pulled the shaft seal. Used the old seal as a seal driver. When putting the cover back on make sure the seal dont roll out. Take a mini screwdriver and tuck it in around shaft. Put bolts back in and tighten like instructions
Read more...
Your Price
$7.88
In Stock
Murray Lawn Tractor Gasket--Crankcase (.015 Thick)
PartSelect Number PS9076878
Manufacturer Part Number 697110
Your Price
$5.71
In Stock
Murray Lawn Tractor Gasket--Exhaust
PartSelect Number PS9294808
Manufacturer Part Number 692236
This OEM exhaust gasket in lawn and garden equipment creates a seal between the engine block and the muffler or exhaust pipe so that exhaust gases do not leak. This is 3.30cm in diameter and 6.35cm in length. Your machine may have a loud hissing or popping sound coming from the exhaust area if the gasket was faulty. You may also notice the presence of black soot around the gasket or the exhaust. Your gasket needs to be replaced if it appears worn or deformed. Otherwise, your machine will experience exhaust leaks. To detach the gasket, remove the fasteners that secure it using a socket or wrench. You can detach the gasket from your machine afterwards. Please bear in mind that this replacement part is sold individually.
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!!
Read more...
Your Price
$6.59
In Stock
Murray Lawn Tractor Seal,Oil
PartSelect Number PS9277860
Manufacturer Part Number 391086S
The Oil Seal is a manufacturer-approved rubber part which provides a seal between the crankcase and crankshaft by attaching around the axle shaft on the crankhouse housing. Installation is rated as "Medium" difficulty and requires a screw driver, wrench set and seal puller. A broken seal will cause a leak, and the part must be replaced. Refer to your make, model and diagram to ensure you're choosing the right part. This part comes in black and gray.
Your Price
$5.34
In Stock
Murray Lawn Tractor Gasket-Exhaust
PartSelect Number PS9063564
Manufacturer Part Number 690970
Installation Instructions
george from HALLWOOD, VA
valve problem causing pushrod damage
pinged valve guide reinstalled head with new gasket inserted rods adjusted valve 15 min. later mowing lawn first time doin such repair note used magnet to pull old rod inside engine to drain left in rotated engine maling sure no parts broken started up and away i went c how long it lasts mower had over6500 hrs.. on it
Read more...
Your Price
$5.60
In Stock
Murray Lawn Tractor Gasket-Float Bowl
PartSelect Number PS8945656
Manufacturer Part Number 281165S
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!!
Read more...
Your Price
$10.51
On Order
Murray Lawn Tractor Gasket--Float Bowl (Nikki)
PartSelect Number PS9066958
Manufacturer Part Number 698781
Your Price
$4.99
In Stock
Murray Lawn Tractor Seal-O Ring
PartSelect Number PS9294749
Manufacturer Part Number 691917
The Seal-O Ring, also known as the gasket, is red in color, made of rubber, and is an OEM part that requires some skill to replace. This part is designed to create a seal between the carburator and manifold, to prevent air from entering. If your engine loses power, creates a hissing noise, or if the gasket appears damaged or your engine running improperly it may be time to replace the part.
If you run the engine and spray the outside of the carburator with soapy water, you can test whether or not the gasket is leaking by listening to the sounds produced. If the sound smooths out then you've found your leaky gasket. Damage may occur over time, especially if the part dries out, and make the part appear stretched or worn out.
When making this medium-difficulty repair, make sure the new gasket is fitted properly between the carburetor and intake manifold.
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!!
Read more...
Your Price
$3.99
In Stock
Murray Lawn Tractor Gasket--Intake
PartSelect Number PS9294790
Manufacturer Part Number 692137
This manufacturer-certified Gasket-Intake, more commonly known as the Intake Gasket, is a gray, 3 x 2 inch, individually sold part which can be installed using a Wrench or Socket and a torque wrench. This part provides a seal between the caburator and intake manifold, and can be easily installed. Just ensure you are tightening to the manufacturer specfications when repairing this part.
If your engine is getting more air than fuel and appears under-powered, it may be a sign this part needs to be replaced. Try spraying a mixture of soapy water at the base of the carburator at the intake manifold with the engine running, and if the engine runs more smoothly then you have discovered the problem.
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!!
Read more...
Your Price
$5.96
In Stock
Murray Lawn Tractor Seal--O Ring (Intake Manifold)
PartSelect Number PS9064038
Manufacturer Part Number 692138
Installation Instructions
FRANK from EASTANOLLEE, GA
Screw can out of the carburator throttle baffel and stuck in the exhaust valve
No compression. Removed the cylinder head. freed the screw, checked the valve to see if it still sealed. Turned the head over with the valves in it, install a spark plug, fill the head dome with gas and see if any leeks out over a 2 hr period. If not you are good to go. Reinstalled every thing with new gaskets and a new carburetor screw. Set the valves to spec. Complete the rebuild and there you have it. Rebuild the carburetor while you have it apart. This motor runs great !!!
Read more...
