Parts That Fix KitchenAid Dishwasher KUDS01FLSS6 Noisy
Noisy is a commonly reported symptom for the KUDS01FLSS6 KitchenAid Dishwasher, and we have put together a full guide on how to fix this. This advice is based on feedback from people who own this exact appliance. We have listed the most common parts for your KUDS01FLSS6 KitchenAid Dishwasher that will fix Noisy. We have included repair instructions, and helpful step-by-step video tutorials. If you are experiencing this issue, not to worry, DIYers just like you have fixed this, and shared their experience to help you!
The circulation pump and motor is located near the bottom of the dishwasher. The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle. Before you begin this repair, it is recommended that you pull your dishwasher out of the cabinet, so you can tip the dishwasher to one side and gain better access to the circulation pump and motor. Be sure to disconnect the power source and the water source to the dishwasher before you begin this repair. To complete this repair you will need a 1/4 inch nut driver and a 3/8 inch nut driver.
This part is a door balance link kit, also sometimes known as door cable or door spring cable kit, that helps support the door as it opens and closes by connecting to the dishwasher door hinges. The kit includes two door balance links and two door balance mounts with wheels, which will replace both the left and right sides. The only tool needed is a 5/16 nut driver. Before removing the existing kit, take note of how the door balance link kit is assembled for a smooth replacement process. It is recommended to check the door springs in case they need to be replaced as well.
This chopper assembly chops up/mince the food particles to prevent from clogging the dishwasher pump.
*** This part no longer includes the Chopper Assembly as per the Manufacturer *** The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.
Also known as a wash arm seal.
This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.
This part is used with the lower spray arm.
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve will open and close according to the desired amount of water needed.
The drain pump ejects the water from the dishwasher.
This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.
Water is supplied to the lower spray arm via the pump assembly.
This part is used to cover the chopper blades.
This seal is located between the spray arm and the water feed tube.
The tub sound shield insulates the tub to reduce noise.
May differ in appearance, but functions same as original. This valve allows the water to flow in the drain direction only and prevents the dirty water from coming back into the tub.
This part releases the detergent and rinse aid into the dishwasher.