Models
>
DW80J3020US
DW80J3020US ((AA)(0001)) Samsung Dishwasher - Overview
Sections of the DW80J3020US
[Viewing 7 of 7]
Keep searches simple, eg. "belt" or "pump".
Lower Rack Roller with Mounting Clip
PartSelect #: PS4222532
Manufacturer #: DD66-00023A
$19.33
In Stock
Dishwasher Door Switch
PartSelect #: PS12394435
Manufacturer #: DD81-02132A
This door switch is for dishwashers.
The door switch detects when the door is closed so the dishwasher can start.
Unplug the dishwasher or shut off the house circuit breaker before installing th...
$65.41
In Stock
Drain Check Valve
PartSelect #: PS4222545
Manufacturer #: DD66-00045A
This part is the replacement drain check valve for your dishwasher. It is made of black plastic and is approximately 1-1/4 inches by 1-1/4 inches. The round section of the check valve is approximately...
$28.60
In Stock
Assembly-SENSOR LEAK;DMT800,
PartSelect #: PS4222735
Manufacturer #: DD94-01062A
This is a leak sensor designed for use with a range of Samsung dishwashers. This sensor is designed to detect if water begins leaking from the water supply. If/when it detects a leak, it stops the wat...
$39.35
In Stock
Duct Nozzle
PartSelect #: PS4222560
Manufacturer #: DD67-00048A
DUCT-NOZZLE;DMT800,PP,T2
$188.80
In Stock
Questions And Answers for DW80J3020US
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the DW80J3020US
[Viewing 3 of 3]Door latch failure
Fixed by
these parts
these parts
Show All
Leaking
Fixed by
these parts
these parts
Show All
Not draining
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
I replaced the pump assembly with a new drain hose
This is not a repair for the faint of heart. You will have to pretty much disassemble the entire dishwasher to replace the main pump assembly. And it’s not cheap, between the pump assembly and the hose...it was over $300...
This dishwasher is Junk...been through 2 motherboards, plastic internal spray arms...and finally a pump a ... Read more ssembly...if you own one and the pump begins to leak....shorts the pump motor out....if it gets this far...but a new dishwasher.
As far as partselect...they are 1st rate.
This dishwasher is Junk...been through 2 motherboards, plastic internal spray arms...and finally a pump a ... Read more ssembly...if you own one and the pump begins to leak....shorts the pump motor out....if it gets this far...but a new dishwasher.
As far as partselect...they are 1st rate.
Read less
Parts Used:
-
Mark from kennewick, WA
-
Difficulty Level:Difficult
-
Total Repair Time:More than 2 hours
-
Tools:Pliers, Screw drivers
8 of 20 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The sump seal began to seep causing the leak detector to lock it out of service (which is good)
The install definitely takes a bit more than the video I watched but in the end all was fine. The electrical and hose connections are nothing but getting the three screws and retainers isn't as easy as shown in the video I watched and getting them back in is even worse. My hands aren't small but they're not huge either. You'll need multip
... Read more
le phillips head screwdrivers. All a #2 head, with one stubby, one about 6" and one long one with about 8" or more of shaft on the screwdriver to remove the screws. Also take pictures if possible with your phone for reconnecting all your wiring harnesses will prove helpful. The only other difficult part of doing it by yourself is compressing the new sump seal enough to get the three nylon retainer clips back into place. There is really need or room for two people on any part of this other than at that point. If you could have somebody push down on the pump unit from inside while you install the retainers it would make it so much easier but I managed. Other than that not a big deal. Good luck!
Read less
Parts Used:
-
Dale from Watertown, NY
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
3 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Front panel did not light up, dishwasher would not come on.
Removed front panel, removed lower plates to expose power source, Found wire broken to front panel. Part of 1 wire missing about 2 inches. Maybe a mouse. Replaced harness and machine working now.
Parts Used:
-
David from PLYMOUTH, NH
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers, Wrench (Adjustable)
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!