Enter the code DIYDAD10 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on June 17 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
This Spark Plug Bpm-8y is a silver and white OEM part. Made of steel and ceramic it is individually sold, and is an electrical part. It is installed with a spark plug socket and is rated as Easy to in...
$3.99
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This part is the replacement stud for your chainsaw. It is approximately 1 ¼ inches long and is black in color. The stud secures the chain bar to the chainsaw. It the stud is damaged or missing, it ca...
$4.99
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This OEM replacement part is used to pump fuel from the tank to the carburetor in order to start the engine. It may also be referred to as a Primer Bulb. It is made of durable black plastic and is sol...
$6.81
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
Used in over 150 models of outdoor power equipment, this clip is commonly used to clip fuel lines or other hoses/tubes in place. It is sold individually, not as part of a kit or assembly, made of meta...
$4.99
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
This spark plug is a genuine OEM part that is used on gas-powered lawn and garden equipment. The spark plug creates the spark that ignites the fuel and air mixture inside the engine, allowing it to ru...
$5.19
In Stock
Order within the next 1 hr and 44 mins and your part ships today!
Questions And Answers for CS-361P
Be the first to ask our experts a question about this model!
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
The unit is a press fit. To remove the old one required breaking the plastic compression tabs that hold it in place. That was simple enough. Replacing requires lining up in the correct position to meet the inner hose. Then push it in. The compression tabs on the replacement click in and hold.in place.
I followed the instructions on Youtube, but I used an Impact drill and ratchet set. The hardest part is assembling the screw on the lower part of the paddle. It helps if you have your snow blower against a wall or something else so that it can not move b/c you will need some strength to push the screw threw the pre-drilled hole to the 10
... Read moremm nut. I used a vise grip to hold the nut do to the lack of space and with my impact driver started to thread the screw to the nut. This part took about 1 min on one side and 10 minutes on the other side. I guess I got lucky the first time. Changing the scraper blade took about 4 minutes start to finish. It will help if you have needle nose pliers to remove and reattach the spring on each side. The instruction on you tube were very helpful. Hope you find this information helpful.