Enter the code DIYDAD10 at checkout to apply your discount. Discount will be applied at checkout when the code is entered & applies to all parts. Cannot be combined with any other coupon or special offer & cannot be applied to a previously placed order. Not valid toward tax or shipping & handling. Discount has no cash value. Discount expires on June 17 at 11:59pm EST.
You've Got 10% Off Your First Order!Save 10% with code at checkout *click to copy coupon code
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
The air was bypassing the compressor gaskets and cylinder wall was worn out
1 remove cover 2 unhook air line to tank 3 remove head bolts 4 remove intake from head 5 remove flywheel bolt to free up pump piston 6 remove screw on top of piston to change out gasket 7 remove the cylinder sleeve install piston from the top 8 reassemble piston rod end and the flywheel 9 on the head cover are two gaskets one on top and one on the bottom head 10 insert intake piece and bolt the head cover back in place 11 reinstall the air line and unit cover and secure with three cover screws
Can't find this special screw used on many housings etc
Actually don't like using Torx bits because they are hard to center deep in the channel. I had misplaced these forcing me to order replacements. My plan is to insert Torx bits before screwing in and using jb weld to secure the bit to the screw, giving me a hex head. Can't find this special screw with a hex head. This screw is called AGC-408 by craftsman.