Microwave Oven Combo Motors
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Microwave Oven Combo Motors
Your Price
$49.17
In Stock
Microwave Oven Combo Microwave Turntable Motor
PartSelect Number PS11755189
Manufacturer Part Number WPW10466420
As per manufacturer this no longer comes with the Spacer.
Fixes these symptoms
- Noisy
- Tray won’t turn
- See more...
Installation Instructions
Michael from YUMA, AZ
Rattling noise when turn table was in motion
Unplug any appliance before any work is done. The microwave is a hanging unit under kitchen cabinets. First I removed the turn table, rollers, and connector by lifting them out. Second I removed all the attaching Phillips head screws that hold the bottom cover on. Once removed the cover will hang and give access to the drive motor gear assembly. It's held in place by 2 torques head screws. Remove these, lower the motor, and disconnect the 2 wires that plug onto it. A small pick or similar tool is needed to release the connectors latches. reassemble in reverse.
Read more...
Your Price
$109.73
In Stock
Microwave Oven Combo Turntable Motor
PartSelect Number PS11769794
Manufacturer Part Number W10911403
Fixes these symptoms
- Noisy
- Tray won’t turn
- See more...
Your Price
$205.99
In Stock
Microwave Oven Combo Blower Motor Assembly
PartSelect Number PS11747998
Manufacturer Part Number WPW10016550
Installation Instructions
Joseph from North Grosvenordale, CT
The original blower squirrel cage failed out balance.
Safety first , I shut off the circuit breaker . I removed the racks from inside the wall oven . I removed the the wall oven from the niche .Then removed the three sheet metal panels in the rear of the oven exposing the mounting screws that hold the blower down .I removed the wires from the blower motor and then the blower assembly ,then I removed the small duct affixed to the blower assembly by a single sheet metal screw and transferred it to the new blower assembly . I installed the adhesive backed foam strip that is a vibration dampener and reassembled in reverse order.Once the over was returned to its original position in the wall mounting I turned the breakers back on and tested the oven ...AAAAAAAAA++++++++++++ To be fair i must admit that I am not a novice at this 15 years of my working career revolved around HVAC and appliance repair ,still however a novice that is mechanically inclined can perform the same task in about 70 to 80 minutes as opposed to my 35 . That is all there is to it.
Read more...
Your Price
$24.85
In Stock
Microwave Oven Combo Motor, AC Synchronous
PartSelect Number PS3529216
Manufacturer Part Number 6549W1S013H
If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed through the bottom. The motor is normally held in place with a retaining screw and will have two wires attached to it as well. If the motor is making a grinding noise it will need to be replaced. If the motor does not turn, you can check for voltage or continuity with a multi-meter. Make sure the power is disconnected from your microwave before beginning this repair.
Fixes these symptoms
- Noisy
- Tray won’t turn
- See more...
Installation Instructions
Susan from HENDERSON, NV
microwave dish would not move back and forth
unscrewed the bottom of the microwave and unplugged old part then took the screw out and put new one in. Super easy!
Read more...
Your Price
$41.43
In Stock
Microwave Oven Combo TURNTABLE MOTOR
motor. Insert the new motor and reverse the procedure.
DIY will save you a $ 95.00 GE repairman labor bill, plus the cost of the motor. I repaired the problem for less than $25.00! Read more...
PartSelect Number PS2370063
Manufacturer Part Number WB26X10233
Fixes these symptoms
- Noisy
- Tray won’t turn
- See more...
Installation Instructions
Mark from LADYS ISLAND, SC
Turn table on microwave would not turn.
Removed 6 screws from the front and back of the bottom of the unit. 3 screws each side. The panel will swing down. Remove the wires from the motor. Remove the one screw from the old motor. Insert the new motor and reverse the procedure.
DIY will save you a $ 95.00 GE repairman labor bill, plus the cost of the motor. I repaired the problem for less than $25.00! Read more...
Your Price
$168.15
In Stock
Microwave Oven Combo MOTOR-CONVECTION
PartSelect Number PS1993372
Manufacturer Part Number 5304463302
Your Price
$62.90
In Stock
Microwave Oven Combo Motor, AC Synchronous
PartSelect Number PS3529223
Manufacturer Part Number 6549W1S018C
Fixes these symptoms
- Tray won’t turn
- See more...
Your Price
$25.13
In Stock
Microwave Oven Combo Motor, AC Synchronous
than unplug 2 wires to the motor and unscrewed 2 screws, replaced the old motor with the new one and also the coupler. and so far no noise. easy fix. Thanks Read more...
PartSelect Number PS3529217
Manufacturer Part Number 6549W1S013K
Fixes these symptoms
- Tray won’t turn
- See more...
Installation Instructions
George from RICHMOND HTS, OH
Was making a noise when turning around
I removed the bottom plate which had 9 screws. than unplug 2 wires to the motor and unscrewed 2 screws, replaced the old motor with the new one and also the coupler. and so far no noise. easy fix. Thanks Read more...
Your Price
$114.20
In Stock
Microwave Oven Combo Microwave Turntable Motor
PartSelect Number PS12722592
Manufacturer Part Number WB26X32190
This turntable motor is for microwaves.
The turntable motor rotates the glass tray inside the microwave oven.
Because high-voltage capacitors in a microwave can retain a lethal electrical charge even when the microwave is unplugged, a service technician should install this part.
Your Price
$191.61
In Stock
