Maytag Dishwasher Thermostats

Videos!

Your Price

$20.75

Maytag Dishwasher High Limit Thermostat

★★★★★

9 Reviews

PartSelect Number PS11743423

Manufacturer Part Number WP661566

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Fixes these symptoms

Not cleaning dishes properly
Not drying dishes properly
Will Not Start
See more...

Installation Instructions

PAUL from ESTES PARK, CO

Unit Wouldn't Work. "Clean" Light Blinking

The unit had power, but the controls would not work. The "clean" light was blinking. I first replaced the control unit, no help. I then used the "just ask" and was told the problem was the heating element and/or the hi-temp thermostat. I replaced both those and used the re-set code pushing the "hi-temp/air dry, hi-temp/air dry" buttons. That did it. Easy parts to locate and replace. It took longer pulling the unit out and putting it back than it did to replace the parts. Read more...

Videos!

Your Price

$45.09

Maytag Dishwasher Thermostat

★★★★★

2 Reviews

PartSelect Number PS11750035

Manufacturer Part Number WPW10195091

This genuine OEM thermostat is sourced directly from the manufacturer to ensure compatibility with your dishwasher model. The thermostat monitors and regulates the temperature of the dishwasher heating element. It is responsible for ensuring that the water temperature reaches the optimal level for effective cleaning while also helping to prevent overheating and potential damage to the internal components of the dishwasher.

Fixes these symptoms

Not cleaning dishes properly
Not drying dishes properly
Will Not Start
See more...

Installation Instructions

Ron from OKLAHOMA CITY, OK

Dishwasher does not finish its cycle. The sanitizer light flashes red and there is soapy water left in the dishwasher.

I replaced the thermostat (part # PS11750035) along with the heating element (part # PS9494999) and the turbidity sensor (part # PS11757214). I also checked the filter (part # PS11759673) and it was very clean with no holes. The dishwasher still has water and soap suds standing in dishwasher after I ran it through different cycles. Also, when I run the sanitize cycle the sanitize light flashes red at the end. It doesn’t appear to completely filling with water. Also my hot water temperature is 130 degrees after running for 1 minute. I am at a loss! Any suggestions? Read more...

Your Price

$41.44

Maytag Dishwasher Limit Thermostat

PartSelect Number PS11747621

Manufacturer Part Number WP99001852

This part is used to sense and maintain the heating element temperature in the dishwasher.

Fixes these symptoms

Not drying dishes properly
See more...

Installation Instructions

Allen from Columbia, SC

Dishes Weren't Getting Clean

I surfed the net using phrases like "dishes not clean" and found a series of possible solutions. When I noticed that the water in the washer was cold, I realized it was a heating element issue. Using a multi-meter set to the lowest resistance I tested both ends of the heating element (OF COURSE I SHUT OFF ELECTRICITY TO THE DISHWASHER FIRST!!!) and found it read a steady 16 ohms. Then I followed the orange leads to the limiter, removed the leads and tested resistance and found it at near zero. Touchdown.

I ordered the new limiter, had it in a couple of days and installed in in 5 minutes. The hardest part was putting the metal cover back on the bottom of the unit.t Read more...