LG Dishwasher Filters

Your Price

$87.68

LG Dishwasher Filter Assembly,Mesh

★★★★★

5 Reviews

PartSelect Number PS3531957

Manufacturer Part Number ADQ32598202

This circulation pump filter in your dishwasher traps food and debris, preventing them from entering the wash cycle again. It is often located at the bottom of the dishwasher. If this filter is broken or clogged, you may notice your dishes are not being cleaned properly, unusual noises, or water drainage issues. This replacement part is sourced directly from the original manufacturer and is sold individually.

Fixes these symptoms

Not cleaning dishes properly
Not draining
See more...

Installation Instructions

Hans from TRYON, NC

Whining motor noise during wash cycle.

The noise is caused by a defective motor bearing. The bearing fails due to water intrusion after the motor shaft seal in the sump assembly starts leaking. It maybe worthwhile to replace the entire sump assembly ( illustr. M007) instead of the motor only to prevent premature failure of the replacement motor.
(Unfortunately the shaft seal is not available as a separate part). Read more...

Your Price

$73.79

LG Dishwasher Noise Filter Assembly

★★★★★

2 Reviews

PartSelect Number PS3528920

Manufacturer Part Number 6201EC1006T

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

JOHN from FORT MYERS, FL

No power to dishwasher. Confirmed that outlet had power coming out.

Turn off circuit breaker. Turn off water at shutoff valve usually located under sink. Disconnect water line from dishwasher. Disconnect wires for the power feed from cord, Marked corresponding wires upon removal for re-installation. Remove 2 mounting screws that secure dishwasher to counter. Slide dishwasher out from counter and turn upside down. Use a blanket to prevent scratching of surfaces. Locate component on the back portion of the dishwasher. Unplug 2 wiring harnesses. My part was held on by 2 phillip screws. One in front, the other in the back along the leg bracket support. Once removed, reverse the order of removal. The i a You Tube video you can locate fr this removal. They said that you needed to release a clip to get the part out. Mine had a screw holding it on the back side. This difference cause about an extra 1/2 hour before I was able to figure out that there was NO clip that was being shown on the video. After that, The replacement went smoothly and we were having the dishes washed later that day. Read more...