Dishwasher Thermostats

Videos!

Your Price

$20.71

Dishwasher High Limit Thermostat

★★★★★

9 Reviews

PartSelect Number PS11743423

Manufacturer Part Number WP661566

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Fixes these symptoms

Not cleaning dishes properly
Not drying dishes properly
Will Not Start
See more...

Installation Instructions

PAUL from ESTES PARK, CO

Unit Wouldn't Work. "Clean" Light Blinking

The unit had power, but the controls would not work. The "clean" light was blinking. I first replaced the control unit, no help. I then used the "just ask" and was told the problem was the heating element and/or the hi-temp thermostat. I replaced both those and used the re-set code pushing the "hi-temp/air dry, hi-temp/air dry" buttons. That did it. Easy parts to locate and replace. It took longer pulling the unit out and putting it back than it did to replace the parts. Read more...

Videos!

Your Price

$45.00

Dishwasher Thermostat

★★★★★

2 Reviews

PartSelect Number PS11750035

Manufacturer Part Number WPW10195091

Fixes these symptoms

Not cleaning dishes properly
Not drying dishes properly
Will Not Start
See more...

Installation Instructions

Ron from OKLAHOMA CITY, OK

Dishwasher does not finish its cycle. The sanitizer light flashes red and there is soapy water left in the dishwasher.

I replaced the thermostat (part # PS11750035) along with the heating element (part # PS9494999) and the turbidity sensor (part # PS11757214). I also checked the filter (part # PS11759673) and it was very clean with no holes. The dishwasher still has water and soap suds standing in dishwasher after I ran it through different cycles. Also, when I run the sanitize cycle the sanitize light flashes red at the end. It doesn’t appear to completely filling with water. Also my hot water temperature is 130 degrees after running for 1 minute. I am at a loss! Any suggestions? Read more...

Videos!

Your Price

$51.07

Dishwasher High Limit Thermostat

★★★★★

2 Reviews

PartSelect Number PS420575

Manufacturer Part Number 154290204

This resettable hi-limit thermostat acts as a safety mechanism that keeps the dishwasher from overheating. This part will cut out if the internal temperature reaches 200 degrees Fahrenheit. It will reset when the temperature drops to 100 degrees Fahrenheit - the differential of 100 degrees.

Fixes these symptoms

Not cleaning dishes properly
Not drying dishes properly
See more...

Installation Instructions

Ewout from Bozeman, MT

Water in dishwasher did not heat up. Dishes came out dirty and greasy. Some fungus started to grow in dishwasher.

Unplugged the dishwasher. Closed and disconnected the water supply. Removed two screws that attached the dishwasher to the countertop. Pulled the dishwasher out from underneath the countertop. Laid the dishwasher on its side to access the bottom. The high limit thermostat had shorted out and showed signs of electrical burn. I removed the high limit thermostat by unscrewing the single screw that holds it in place. I then pulled the two electrical terminals off the high limit thermostat . One terminal (i.e. small electrical plug connecting electrical wire to high limit thermostat) was burned badly. I cut it off the wire and attached a generic terminal bought at local hardware store (six for $3). The other terminal was fine. I plugged the new high limit thermostat in and attached it with the single screw to the dish washer. Put the dishwasher back in place. Test ran dish washer and dishes came out shiny, clean and dry. Done. Read more...

Your Price

$48.11

Dishwasher Cycling Thermostat - L150-25F

PartSelect Number PS11757517

Manufacturer Part Number WPY304474

This thermostat controls the internal drying temperature. Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 150 degrees Fahrenheit and a differential of 25 degrees. Meaning that with this thermostat, the heating element will cut out at 150 degrees and cycle back on once the internal temperature drops by 25 degrees.

Fixes these symptoms

Too hot
See more...

Installation Instructions

Waldon from MOSES LAKE, WA

the drum belt broke so the dryer is 30 years old & this is first problem so i replaced other parts also

took off front panel took off front drum cover, removed drum, replaced rear carrer rollers, drilled out pop rivets on front tub cover and replaced drum glides, replaced all three thermostats, replaced drum belt idler wheel,replaced motor drum belt, put front panel back on , pluged it back into power and it run like new. We purchased this Maytag set in 1987 new and this was the first time for any repairs of any kind, so while it was all apart I replaced other parts also, since it was 30 years old, maybe it will last another 30 years. " I won't I am 83 years old " you have to love maytag Read more...

Your Price

$23.42

Dishwasher THERMOSTAT

PartSelect Number PS8746670

Manufacturer Part Number 154227811

Your Price

$41.36

Dishwasher Limit Thermostat

PartSelect Number PS11747621

Manufacturer Part Number WP99001852

This part is used to sense and maintain the heating element temperature in the dishwasher.

Fixes these symptoms

Not drying dishes properly
See more...

Installation Instructions

Allen from Columbia, SC

Dishes Weren't Getting Clean

I surfed the net using phrases like "dishes not clean" and found a series of possible solutions. When I noticed that the water in the washer was cold, I realized it was a heating element issue. Using a multi-meter set to the lowest resistance I tested both ends of the heating element (OF COURSE I SHUT OFF ELECTRICITY TO THE DISHWASHER FIRST!!!) and found it read a steady 16 ohms. Then I followed the orange leads to the limiter, removed the leads and tested resistance and found it at near zero. Touchdown.

I ordered the new limiter, had it in a couple of days and installed in in 5 minutes. The hardest part was putting the metal cover back on the bottom of the unit.t Read more...