Crosley Washer Dryer Combo Thermostats

Videos!

Your Price

$28.02

Crosley Washer Dryer Combo Dryer Cycling Thermostat

★★★★★

97 Reviews

PartSelect Number PS11741405

Manufacturer Part Number WP3387134

This thermostat (Dryer Operating Thermostat, Dryer Cycling Thermostat, Cycling Thermostat, Dryer Thermostat) is used to maintain a temperature of 155 degrees in the dryer drum. The internal bias heater also allows this thermostat to provide a low heat temperature of approximately 140 degrees when the low temperature setting is selected. The part measures 2 by 1.5 inches, comes in black/silver and is constructed of plastic and metal. The thermostat attaches to the blower wheel housing.

Fixes these symptoms

Heat stays on after drum has stopped
Not Heating
Too hot
See more...

Installation Instructions

Tom from High Point, NC

Dryer blew cold air.

PartSelect is great for providing parts as requested. Unfortunately, neither of the 2 parts I ordered were on my machine. My bad for not looking at the actual part instead of the description. A word to the wise! Read more...

Videos!

Your Price

$36.65

Crosley Washer Dryer Combo Thermal Cut-Off Kit

★★★★★

135 Reviews

PartSelect Number PS334299

Manufacturer Part Number 279816

The thermal cut-off (Dryer Thermal Cut-Off Fuse Kit, Dryer Thermal Cut-Off Kit) prevents the dryer from overheating when the dryer high limit thermostat fails in a closed circuit condition. This part fails when the heater housing does not have adequate airflow through it; this is normally caused by restriction in the exhaust vent, plugged lint screen, or broken blower wheel. If this part fails, the dryer may not produce any heat. This kit includes one high-limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse (309 degrees), jumper wires, and new female spade terminals. Both components are mounted on the heater housing, and measure approximately 2 inches long and 1.5 inches wide each. This kit comes in silver and is constructed of metal.

Fixes these symptoms

Heat stays on after drum has stopped
Not Heating
Too hot
See more...

Installation Instructions

Vernon from Niceville, FL

No Heat

First tried heating element and thermal fuse with no luck. Ordered thermal cutoff and fixed problem. Had I used an ohm meter first I would have determined problem before having ordered heating element and fuse, as both had resistance. I wast just lazy and ordered the took the most common failed components first before taking dryer back off. Read more...

Videos!

Your Price

$28.90

Crosley Washer Dryer Combo Thermal Cut-Off Kit

★★★★★

61 Reviews

PartSelect Number PS334278

Manufacturer Part Number 279769

This kit includes one high limit thermostat with a limit of 250 degrees Fahrenheit, and one thermal cut-off fuse with a limit of 360 degrees Fahrenheit. The thermostat and fuse help prevent the dryer from overheating.

Fixes these symptoms

Not Heating
Too hot
See more...

Installation Instructions

Wesley from Boyds, MD

Dryer not heating

Our dryer is 8 years old and had been slowly taking longer and longer to dry clothes, to the point that I was ready to purchase a new one. When the dryer stopped heating completely, I removed the bottom panel and found that the heating element was no longer working. I checked online and found this website. The top two recommended fixes for this issue was to replace the heating element and/or thermal cut-off kit (two sensors). I chose to purchase both, delivered to me very quickly (two days). I figured for $80 you can't go wrong. Here's the procedure I followed:

On my particular model, the back does NOT come off and all of my repairs had to be made via the front, bottom panel.

(1) disconnected 6 wires (3 pairs) from the heating element and two thermal sensors
(2) removed entire heating element 'sleeve" which contained both the heating element AND the two sensors. The space is way too tight to try and do this any other way (and I highly recommend this method to save a ton of time and frustration.)
(3) vaccummed out the entire inside of the dryer, clearing all lint and debris, including tons of lint creating a blockage, thus slowing the ability to dry over the years
(4) replaced sensors and heating element
(5) installed heating element & Thermal sensors back inside and reconnected all wires
(6) tested dryer to ensure that heating element lit up and produced heat - it worked beautifully!

Besides fixing the heating issue, cleaning out the clogged lint pipe at the back of the dryer and wall have made the old dryer new again. It's working better than ever! Read more...

Videos!

Your Price

$86.01

Crosley Washer Dryer Combo High Limit Thermostat

★★★★★

2 Reviews

PartSelect Number PS446428

Manufacturer Part Number 3204267

This high limit thermostat is used in a dryer and monitors the temperature to make sure it does not exceed 260 degrees Fahrenheit. When your dryer temperature reaches 260 it will cut it out and only comes back when it drops by at least 70 degrees Fahrenheit. If your dryer is overheating, taking too long to dry clothes, or is not producing enough heat, replacing the thermostat could be the solution to your problem. The tools needed for this part are a Phillips screwdriver, putty knife, and needle nose pliers. Refer to the manual provided by the manufacturer for installation instructions and guidance.

Fixes these symptoms

Too hot
See more...

Installation Instructions

MELISSA from OKEECHOBEE, FL

dryer does not get very hot, takes two cycle's to dry

removed the screws, disconnected the wires. installed the new elements replaced the wires. Read more...

Videos!

Your Price

$45.62

Crosley Washer Dryer Combo Control Thermistor

★★★★★

2 Reviews

PartSelect Number PS1149368

Manufacturer Part Number 134587700

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.

Fixes these symptoms

Too hot
See more...

Installation Instructions

Don from RUIDOSO, NM

Dryer cut off before the clothes were dry.

All the symptoms indicated the thermister (located in the exhaust air stream of the dryer) was the problem. Pulled the lower panel off the dryer. Took out the two lower screws holding the door panel on so I could pull the front panel out just enough to get a screwdriver on the screws holding the thermister on. Unhooked the two wires connected to it and hooked them to the new thermister(no need to observe polarity). Put the new thermister in, screwed the door panel back down, put the lower panel on and started drying clothes. Read more...

Videos!

Your Price

$66.38

Crosley Washer Dryer Combo High Limit Thermostat

★★★★★

4 Reviews

PartSelect Number PS11741441

Manufacturer Part Number WP3390291

With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 250 degrees Fahrenheit. The element will kick back in when the temperature drops to 190 degrees Fahrenheit. Differential of 60 degrees.

Fixes these symptoms

Too hot
See more...

Installation Instructions

Tom from High Point, NC

Dryer blew cold air.

PartSelect is great for providing parts as requested. Unfortunately, neither of the 2 parts I ordered were on my machine. My bad for not looking at the actual part instead of the description. A word to the wise! Read more...

Your Price

$33.97

Crosley Washer Dryer Combo Cycling Thermostat - 4 Terminal

PartSelect Number PS417453

Manufacturer Part Number 131298300

This operating or cycling thermostat is used in dryers to monitor and direct the temperature inside the dryer. If your thermostat is shorted out and it will not allow the heat to come on, it is best to replace it. The tool needed for this repair is a 1/4 inch nut driver. The first step for this repair is to access the back panel and remove the screws. Next, remove wires connected to the thermostat and remove the screw to pull out the thermostat. Now you can install new thermostat. For further installation instructions, refer to the diagram provided by the manufacturer. As a safety precaution, remember to unplug your appliance from the power source before starting this repair.

Fixes these symptoms

Too hot
See more...

Installation Instructions

Patrick from Humble, TX

squeeking/ grinding really bad

First I pryed up the top cover then opened the access cover on the rear to remove the belt from the drum. Next I removed the front of the dryer to have access to remove the drum. I then removed the 3 screws that hold the drum to the rear drum bearing assembly and pulled the drum through the front of the dryer. I then removed the bearing and proceded to remove the ground ball and reassembled in reverse steps. Read more...

Your Price

$87.70

Crosley Washer Dryer Combo Cycling Thermostat

PartSelect Number PS419278

Manufacturer Part Number 134048800

Fixes these symptoms

Too hot
See more...

Installation Instructions

marjorie from Cary, NC

Dryer was getting very hot

I watched videos so I would know what I was doing. Well No, My thermostat was in the front of the dryer. But after a little blood and sweat, and I am not kidding, I got the front off. I ordered my new part. Finally got it in Spent $40.00 and it still doesn't work. I know it was the right part. I checked all the trouble shooting web site. That was the only thing they said it would be. Friends advice tell me it is the brains of the thing and I need a new one. Well not 2 weeks before Christmas. Thanks for asking. Single hard working mom. Read more...