Cooktop Filters

Your Price

$38.84

Cooktop Grease Filter

★★★★★

25 Reviews

PartSelect Number PS11743846

Manufacturer Part Number WP707929

The function of the grease filter is to trap grease into the filter from the exhaust air. The grease filter is intended to be used with certain downdraft cooktops and ranges. This grease filter is roughly fourteen inches long and almost twelve inches wide, and chrome in color. Removing your old grease filter and replacing it with a new one is an easy job, users say it took them less than fifteen minutes to install. We recommend that when removing your current grease filter, you use work gloves to protect your hands and clean the entire area thoroughly before installing the new filter.

Fixes these symptoms

Touchpad does not respond
See more...

Installation Instructions

ELOISE from MILFORD, OH

replaced filter

pulled old one out , cleaned the area & replaced with the new one. Read more...

Your Price

$48.41

Cooktop Downdraft Vent Grease Filter

★★★★★

31 Reviews

PartSelect Number PS11757584

Manufacturer Part Number WPY706012

This is a grease filter, and it works with your range/stove/oven. This part is chrome-colored and measures 16.5 inches long by 9 inches wide. It is made of metal and is intended for use with downdraft ranges and cooktops. The function of this part is to ventilate the air while cooking. By doing this, the grease filter will trap debris and cooking residue from the exhaust air. There are no tools required for you to complete this installation. Before putting in your new filter, it is best practice to wipe the area down after your old piece was removed.

Installation Instructions

Johnnie from Daphne, AL

Replace Grease Filter For Downdraft Stove Top

Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not covered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done. Read more...