Amana Dishwasher Wheels and Rollers
- Search your model number to find:
- Genuine OEM parts guaranteed to fit
- Free manuals and guides
- Repair instructions and videos
Popular Amana Dishwasher Wheels and Rollers
Your Price
$46.04
In Stock
Amana Dishwasher Lower Dishrack Wheel
PartSelect Number PS3406971
Manufacturer Part Number W10195416
This OEM gray Dishwasher Lower Dishrack Wheel Assembly is a plastic kit that allows the rack to slide in and out of the dishwasher easily. If it breaks or becomes damaged. sliding will feel difficult. This can happen due to normal wear and tear, and the part should be replaced if this occurs. Check your model number and user manual to make sure this part is correct. It attaches directly to the dishrack. To repair, open the dishwasher door and pull out the lower dishrack. Next, push the tab from both sides and it should pop out. To install the new wheel assembly, place it on the rack and make sure the caps overlap the wire from the inside before you clip it in place by pushing the wheel. It measures roughly 3x6 inches.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Leaking
- See more...
Installation Instructions
Thomas from WEST OLIVE, MI
Broken wheel unit on the bottom dish rack
All you do is pop out the old wheel unit at two (2) points on the plastic wheel housing and pop in the new one. Easy fix. Less than a 5 minute fix.
Read more...
Your Price
$11.10
In Stock
Amana Dishwasher Rack Adjuster
PartSelect Number PS11750255
Manufacturer Part Number WPW10204131
This OEM dishrack roller and adjuster is found in your dishwasher. They work together to support and facilitate the smooth movement of your dishrack. The dishrack rollers are small wheels located on the sides of the dishrack and allow it to slide in and out effortlessly. Meanwhile, the dishrack adjuster is used to adjust the height via the selector at the back of this component. Over time, the rollers wear out. You may experience resistance or difficulty when sliding the dishrack in or out. If left unreplaced, your rollers or adjuster may break, causing dishes to tilt, collide, or fall over during the wash cycle. When removing a roller and adjuster from your appliance, you will need to pull out the dishrack partway. Detach the assembly by depressing the tabs on the two end stops before lifting them up. Keep in mind that the roller and adjuster are sold together, but the dishrack itself is sold separately.
Installation Instructions
Randy from Glenview, IL
Replacement of broken Rack Assembly Mount with Wheel
The only piece that may be a little difficult to remove here without a tool is the 'Track Stop'. This piece has a couple of clip-like pieces that need to be depressed in order to remove it. A flathead screw driver will do the trick. Once this piece is out and you have popped the Mount off of the Rack, you simply roll the piece out of the track, roll the new one in and snap the new Mount in place, replacing the Track Stop when you are done. VERY EASY!
Read more...
Your Price
$29.38
In Stock
Amana Dishwasher Upper Rack Wheel with Mount
PartSelect Number PS11745451
Manufacturer Part Number WP8268655
This is a replacement upper dish rack wheel with mount for your dishwasher. The mount supports the dish rack, and the wheel allows the rack to slide out easily. To replace this part, remove the rack stops and pull out the upper dish rack. This wheel mount pops off, and the new one can be snapped into place.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Noisy
- See more...
Installation Instructions
James from Gulfport, MS
The wheels on the upper dish rack broke
I removed the end caps on the slides with needle nose pliers, removed the old wheels and installed the new ones, then I snapped the slide end caps back on. Super responsive service from PartSelect.com Thanks!
Read more...
Your Price
$16.20
In Stock
Amana Dishwasher Lower Wheel Assembly
PartSelect Number PS11747757
Manufacturer Part Number WP99003149
The lower wheel assembly in your dishwasher allows the lower dish rack to roll in and out effectively. If you notice that one of the dish rack wheels is damaged or missing, this is the part you will need to replace it. This part consists of the wheel and axle or clip that holds it on the dish rack. This wheel assembly is sold individually. This lower wheel assembly is made of plastic, is gray in color and the wheel itself is approximately 1 and 3/4 inches in diameter. Many of our customers have rated this repair as easy. To complete this repair, simply remove the old wheel assembly, and snap the new one into place.
Fixes these symptoms
- Door latch failure
- Noisy
- Not cleaning dishes properly
- See more...
Installation Instructions
Kathryn from Oak Creek, CO
One of the wheel assemblies fell off and melted in the dishwasher.
I ordered the part and snapped it on. It was so easy to find the part on the website and it came very quickly. I am a satisfied customer!
Read more...
Your Price
$51.61
In Stock
Amana Dishwasher Dishrack Roller Assembly
PartSelect Number PS11769236
Manufacturer Part Number W10888592
Installation Instructions
Sally from COCHRANVILLE, PA
These 3 parts were broken or missing.
I had to watch a You Tube Video and the Repair was basically snapping these parts on the rack and glide. No tools needed!
Read more...
Your Price
$12.46
In Stock
Amana Dishwasher Lower Wheel Assembly
PartSelect Number PS11747717
Manufacturer Part Number WP99002780
This lower dishrack roller is less than two inches in diameter. It is made entirely of white plastic. If you find that your dishwasher is making loud noises or the lower rack is getting stuck when you are moving it in or out, it could be that the lower wheel assembly needs to be replaced. The dishrack wheels allow for easy movement of the dishrack in and out of the dishwasher. These rollers tend to wear down at the same speed, so it is recommended to replace both pairs at the same time. Open your dishwasher and remove the bottom rack, locate the locking tab, and rotate until it easily slides out of place. Slide the new wheel over the shaft and locate the locking tab to snap back into place.
Fixes these symptoms
- Noisy
- Not cleaning dishes properly
- See more...
Installation Instructions
Walter from Tucson, AZ
Broken latch handle
The hardest thing was figuring out that you only need to purchase the latch handle because it only comes as a complete latch assembly, why they even list the latch assembly as a separate part in the parts list stupid. (you get the handle and latch already put together and it cost less than the latch assembly without the handle). Anyway all you need to do is disconect the power from the dishwasher (unless you like to live dangerously like me) take your drill with the correct size torx bit and remove all the screws on the inside door pannel (the top center two screws actually hold the latch assembly in place). Disconect the 4 wires from the old part and reconect them to the new part and reinstall all the torx screws being careful not to strip the plastic threads that they screw into if you are using a drill. Whole process takes less than 5 minutes. I am surprised that Maytag used such a flimsy handle assembly in their dishwashers since they are supposed to have the repair men with the most time on their hands. They probably sell just as many handle assemblies as they do dishwashers that have this particular part in it, probably more since you will probably have to change it 2 or 3 times during the life of the unit.
Read more...
Your Price
$16.20
In Stock
Amana Dishwasher Upper Rack Wheel
PartSelect Number PS11747755
Manufacturer Part Number WP99003147
Sold individually.
Fixes these symptoms
- Door latch failure
- Door won’t close
- Noisy
- See more...
Installation Instructions
Anthony from Greenwich, CT
Your Price
$58.66
In Stock
Amana Dishwasher Wheel Assembly
T. Edwards Read more...
PartSelect Number PS11745449
Manufacturer Part Number WP8268645
Sold Individually - 4 required on rack.
Installation Instructions
Timothy from huntersville, NC
The dishtrack wheel came off the track and fell into the dishwasher and melted
I snapped on the new part onto the track. It was that easy! :) Thank goodness the part was available from Part Select!T. Edwards Read more...
Your Price
$16.38
In Stock
Amana Dishwasher Lower Front Dishrack Wheel
PartSelect Number PS259136
Manufacturer Part Number WD12X271
The lower dishrack wheel on your dishwasher allows the dishrack to roll in and out effectively. If your lower dishrack wheels are damaged, or the rack does not roll in and out, you may need to replace them. This wheel is located on the front lower rack and includes the axle. This part is sold individually. The wheel and the axle are made of white plastic. The lower front dishrack wheel is approximately 1.5 inches in diameter. To complete the repair, simply detach the damaged wheel and axle from the rack, and install the new one by snapping the axle in place.
Fixes these symptoms
- Door won’t close
- Not cleaning dishes properly
- See more...
Installation Instructions
Julie from Maumee, OH
Wheel broken off bottom rack
Open the tiny plastic package in inserted the wheel onto the "axle". Opened the dishwasher, pulled out the bottom rack and snapped the wheel onto the rack. Done!
Read more...
Your Price
$17.19
In Stock
Amana Dishwasher White Dishrack Roller
PartSelect Number PS11746834
Manufacturer Part Number WP903093
This upper dishwasher dishrack roller, also known as a dishrack wheel, allows you to roll the dishwasher rack easily on the support rails. If your dishwasher rack is disconnected or the rack is broken, then replacing this part might be the solution. The first step in this repair is to remove the upper dishrack from the track, the next step is to remove the defective rack roller and replace it with the new one by sliding it onto the shaft and locking it in. No tools are required for this replacement and customers rate this project as easy. The roller is entirely made from plastic and is just over an inch in diameter.
Fixes these symptoms
- Not cleaning dishes properly
- See more...
Installation Instructions
Kathy from Lombard, IL
Rack roller broke
I opened the end stop of the rack, replaced the roller, and put the end stop back on. I can't believe I paid the repairman the last time $125????? An he put in a regular screw that rusted and broke the roller. Took me 3 minutes! Thanks
Read more...
Related Amana Dishwasher Parts
- All Amana Dishwasher parts
- Amana Dishwasher Brackets and Flanges
- Amana Dishwasher Caps and Lids
- Amana Dishwasher Dishracks
- Amana Dishwasher Dispensers
- Amana Dishwasher Handles
- Amana Dishwasher Hardware
- Amana Dishwasher Hinges
- Amana Dishwasher Hoses and Tubes
- Amana Dishwasher Latches
- Amana Dishwasher Panels
- Amana Dishwasher Pumps
- Amana Dishwasher Seals and Gaskets
- Amana Dishwasher Spray Arms
- Amana Dishwasher Springs and Shock Absorbers
- Amana Dishwasher Switches
