Kenmore Washer Doors

Videos!

Your Price

$139.23

Kenmore Washer Washing Machine Door Lock Assembly

★★★★★

22 Reviews

PartSelect Number PS12704713

Manufacturer Part Number W11307244

This is lid lock designed for use within various washing machines. This lid lock, also known as a latch assembly, is used to secure the lid of your washing machine during the washing cycle. If your washing machine is experiencing issues starting or if the lid is not securing, this lid lock assembly likely needs to be replaced. This lid lock attaches underneath the top portion of your washer and its wire harness connects to the rear of the appliance. To replace this assembly, you will need a screwdriver, flathead screwdriver or putty knife, and wrench. This lid lock is an OEM part that is sold individually and does not come with any other parts or accessories.

Fixes these symptoms

Lid or door won’t close
Locking Issues
Will not agitate
See more...

Installation Instructions

John from BEAVER DAMS, NY

latch switch was not working

unfasten top from back, slide top forward and lift up, remove switch and cable (one piece), in stall new switch and cable, put top down and slide back, reinstall screws. Read more...

Your Price

$203.57

Kenmore Washer Exterior Door Panel - White

★★★★★

2 Reviews

PartSelect Number PS3490391

Manufacturer Part Number 137265500

Fixes these symptoms

Lid or door won’t close
See more...

Videos!

Your Price

$222.56

Kenmore Washer Door Glass

★★★★★

3 Reviews

PartSelect Number PS1145708

Manufacturer Part Number 134366400

Fixes these symptoms

Leaking
See more...

Installation Instructions

Gennaro from Nutley, NJ

Glass inner door cracked due to machine rocking

Simply removed several screws around inner glass Then part set right into place. replaced all the screws and was completed. Read more...

Your Price

$154.69

Kenmore Washer Inner Door Panel Kit - White

PartSelect Number PS975857

Manufacturer Part Number 134426500

Fixes these symptoms

Leaking
See more...

Installation Instructions

Jon from Stevens Point, WI

Rubber seal (boot) needed to be replaced.

I began by removing the seal from the exterior lip of the machine housing. I took a razor and removed any rubber and adhesive that remained on the unit.

Next, I remove the boot from the soap dispenser tube (located at about 11:00 of the opening) with a needlenose plyers. The manual recommends flattening a 3" copper pipe to fashon a tool to release the "bread tie" fastener. I can see why but patience with a needlenose sufficed.

I pulled the boot down from the tub housing (with much force) exposing the band that holds the boot in firmly. I one pull, both pieces came out. I could tell getting the new one is was going to be a chore.

I cleaned the area and after about 40 strenuous minutes of getting the new boot onto the tub, only a couple things remained. Even with help, be prepared to dedicate hours of frustration getting the band around the boot securing it to the tub. The working space is minimal and the task is virtually hopeless to slightly possible.

Once that's taken care of, you may feel like you can accomplish anything. The rest goes up in the order it came out. Make sure you slide the boot up as far up the soap dispensing unit as possible before securing the bread tie clamp.

Run the seal around, close the door and have one of you kids clean up the work area (and mop the blood, sweat and tears from the unit and the floor. Read more...