There are two different couplers (also known as a turntable shaft) that can be used for this tray - a male D-shaped shaft and a female D-shaped shaft. The couplers are sold separately.
$106.43
In Stock
Order within the next 11 hrs and your part ships today!
The stirrer fan cover in your microwave can be found on the roof of the microwave. It protects the fan from damage and debris. This fan cover is made of white plastic and is approximately 7.5 inches i...
$21.48
In Stock
Order within the next 11 hrs and your part ships today!
This is the replacement damper bracket for your microwave. It is made of plastic and is approximately 11 inches wide and 3 inches long. The damper bracket attaches to the outer cabinet and directs air...
$8.56
In Stock
Order within the next 11 hrs and your part ships today!
This part is the replacement high-voltage diode for your microwave. It is approximately 3 inches long and is sold individually. The high voltage diode is an electrical current control device inside yo...
$8.56
In Stock
Order within the next 11 hrs and your part ships today!
This is the replacement monitor switch for your microwave. It is black in color and measures approximately 1 inch by ¾ of an inch. This switch monitors the door latch position of your microwave and co...
$24.84
In Stock
Order within the next 11 hrs and your part ships today!
This part is the replacement plastic rivet, or stirrer fan cover clip for your microwave. It is made of white plastic and is approximately ¼ inch in diameter, and ½ inch long. The plastic rivet holds ...
$9.51
In Stock
Order within the next 11 hrs and your part ships today!
This charcoal filter is a genuine OEM replacement part that is compatible with various models of microwave. It has a length of approximately 8 inches by 5 inches. The filter is designed to absorb odor...
$12.50
In Stock
Order within the next 11 hrs and your part ships today!
This grease filter is a genuine OEM replacement part that is compatible with various models of microwave. It has dimensions of 7.5 inches by 5 inches and it is made of durable aluminum mesh material. ...
$8.56
In Stock
Order within the next 11 hrs and your part ships today!
This fan blade, also known as a stirrer blade, is a genuine OEM replacement part for your microwave. This is a fairly easy repair. To complete it, you will need a screwdriver to disassemble the fan as...
Remove microwave outer cover. Turn on side & locate the upper & lower door switches. Better to replace in pairs even if one is ok. Remove the wire harness to each switch. Then replace switch and re connect the wire harness. Re attach outer cover and test to see if that solved the problem. If so then well done!!
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reco
... Read morennect wires, reseat latch mount by placing top bracket tab in place first, allign and secure with screws. Reseat touch pad by placing bottom tabs in first, tilt forward and press up to seat top tabs, secure with top screw. Secure vent louver screws, plug in and watch your microwave work again.
I followed the generic trouble shooting directions on the web site. It suggested either diode, capacitor and/or magnetron. I test each. All tested OK except diode. It was supposed to measure open in one direction and appox 200k ohms in the other direction. My diode measured open in both directions (tried multiple times, multiple sett
... Read moreings). I replaced the diode. The order process was great and it shipped immediately. I knew I was in trouble when I measured the new diode and it too was open in both directions. It was easy to install but unfortunately no joy - did not solve the problem. At this point it is likely cheaper just to buy a new one