Kenmore Refrigerator Hoses and Tubes

Find Your Part

Model number locator Need help finding your model number?
  • Search your model number to find:
  • Genuine OEM parts guaranteed to fit
  • Free manuals and guides
  • Repair instructions and videos
Kenmore Appliance Parts
Shop By Part Type

Popular Kenmore Refrigerator Hoses and Tubes

Videos!
Your Price
$39.43
  In Stock
Kenmore Refrigerator P-Trap Drain Tube Kit
★★★★★
★★★★★
30 Reviews
PartSelect Number PS8691807
Manufacturer Part Number W10619951
The p-trap drain tube kit may also be known as the duck bill, or the drain pipe, and it is compatible with your refrigerator. The function of the p-trap drain kit is to carry the water that has formed during the defrost cycle to the bottom of the refrigerator, where your drain pan is located. The tools you will need for this repair include a 1/4-inch nut driver and a small flat-blade screwdriver. To do this repair you will need to pull the refrigerator forward in order to reach the lower access panel at the back. This kit includes the tube extension piece and spacer.
Fixes these symptoms
  • Freezer not defrosting
  • Fridge too warm
  • Frost buildup
  • See more...
Installation Instructions
Jack from DINUBA, CA
Water leaking from bottom of refrigerator onto floor
The video on website is very good and explains everything in detail. Just follow the directions. This is EASY!!!! Read more...
Your Price
$16.92
  In Stock
Kenmore Refrigerator Plastic Tube - 5/16 Inch
★★★★★
★★★★★
19 Reviews
PartSelect Number PS3536013
Manufacturer Part Number MJU62070602
This water tube, or plastic tube, is used in refrigerators and freezers. The tube ensures water is directed to parts of the refrigerator that need it, such as the water dispenser and ice maker. If you find that your current one is leaking or broken in any way, replacing the tube can fix this problem. Make sure to unplug the appliance from the power source before you start this installation project. Refer to the diagram provided by the manufacturer for further instruction and accurate guidance.
Fixes these symptoms
Installation Instructions
Debbie from FISHER, AR
Broken water line
Remove water filter and water filter holder. Removed cover on back of frig. Removed clip where water line connects to back of water filter. Took half inch wrench pushed in on water line lock to release line. Repeat at other end. Reverse steps to put on new line. Easy repair. Read more...
Videos!
Your Price
$9.03
  In Stock
Kenmore Refrigerator Union Connector - 5/16 Inch to 5/16 Inch
★★★★★
★★★★★
10 Reviews
PartSelect Number PS758446
Manufacturer Part Number WR02X11330
Quick connector for plastic water line - 5/16" to 5/16"
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Marty from West Bloomfield, MI
Internal water lines brittle, cracked, leaking
First of all, the larger white plastic tubes in this thing are 5/16" OD, which no plumbing store seems to stock. At the lower left rear end there are 2 tubes, one for water and one for ice, that are doomed to fail being in proximity of a heat source - they essentially get cooked to the point of becoming brittle and cracking. The smaller tube and union can be easily found, but do yourself a favor if the larger one cracks and order the plastic tube and water tube union here, and just cut off the brittle part and amend the old tube using the union. Read more...
Videos!
Your Price
$10.14
  In Stock
Kenmore Refrigerator Ice Maker Water Fill Tube Kit
★★★★★
★★★★★
24 Reviews
PartSelect Number PS11739222
Manufacturer Part Number WP2196157
The icemaker water fill tube provides water to the icemaker so it can produce ice and dispense water. If you notice that your ice maker is not making or dispensing ice, or is leaking, you may need to replace the water fill tube. This water fill tube kit comes with a fill tube and a compression nut. This part is made of white plastic and is approximately 10 inches in length. The ice maker water fill tube is in the rear of the fridge. To complete this repair, you will need a 1/4 inch nut driver and a utility knife. Before beginning this repair, you may want to disconnect the water and power supply to the refrigerator.
Fixes these symptoms
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • Leaking
  • See more...
Installation Instructions
Charles from Orland Hills, IL
Broken elbow on icemaker water fill tube.
Removed 2 screws holding water fill tube to rear of refrigerator and pulled out, matched old part with new to make sure of proper match. Guide new fill tube thru hole, making sure it is aligned with slot in ice cube tray on inside of freezer. Install new plastic line from water pump outlet to water fill tube, check for leaks, job done. Read more...
Videos!
Your Price
$46.79
  In Stock
Kenmore Refrigerator Filter Inlet Water Tube
★★★★★
★★★★★
16 Reviews
PartSelect Number PS886401
Manufacturer Part Number 8201597
As per the manufacturer, this part starts out as 1/4" tubing but ends up at 5/16".
Fixes these symptoms
Installation Instructions
George from Hernando, MS
Pur Water filter ruptured could not remove from housing
Removed two screws holding the filter housing. Pulled filter and housing out far enough to remove inlet and outlet lines.Replaced inlet and outlet lines( precautionary) in filter housing, installed new filter. Read more...
Videos!
Your Price
$36.12
  In Stock
Kenmore Refrigerator Water Tube Kit
★★★★★
★★★★★
7 Reviews
PartSelect Number PS11730901
Manufacturer Part Number W10823511
This is the replacement water tube kit for your refrigerator. This tubing is made of plastic, is 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube, and may need to be cut. This water tube transports water to the ice and water dispensers. If your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube. This part is sold individually and is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
  • Ice maker not making ice
  • Leaking
  • Not dispensing water
  • See more...
Installation Instructions
Trent from Tacoma, WA
water dispenser started leaking
i wasn't sure it was the inlet valve unit because the leak was at the water dispenser in the freezer door. after some research it looked like the water inlet valve located in the back lower part of the refrigerator was the problem. to replace, take off the cardboard cover, about 6 screws, you have access to the water inlet valve, disconnect the hoses (i think it goes without saying that you should have turned off the water to the frig) replace the inlet valve, connect hoses, turn water back on and you'll be back in business. very easy repair. Read more...
Your Price
$46.07
  In Stock
Kenmore Refrigerator Ice Maker Fill Tube Assembly
PartSelect Number PS6448034
Manufacturer Part Number 241850615
This supplies water to the icemaker and dispenser.
Fixes these symptoms
Installation Instructions
Fred from LAKE JACKSON, TX
Supply lines needed replacement
The line for the water to the door was too short to install. Lacked about 4-6”Ice maker line was fine. Read more...
Your Price
$9.35
  In Stock
Kenmore Refrigerator Holder,Pipe
PartSelect Number PS3535430
Manufacturer Part Number MEG61879201
Fixes these symptoms
Videos!
Your Price
$110.36
  In Stock
Kenmore Refrigerator Nozzle and Tube Kit
★★★★★
★★★★★
7 Reviews
PartSelect Number PS11742481
Manufacturer Part Number WP4388152
This kit is intended for use with refrigerators that have a water dispenser in the door.
Fixes these symptoms
Installation Instructions
Robert from Abingdon, MD
water dispenser tube broke
To put the new tube in, I cut the old tube before the Y piece(screw to door part) and taped the new hose to it. I pulled the old tube from the bottom of the door, while gently pushing/feeding the new hose in until the new hose was at the bottom of the door. Connected the new hose(top/bottom) and turned the water back on. All of 7 minutes.
Thanks for the fast service... Read more...
Your Price
$19.22
  In Stock
Kenmore Refrigerator Plastic Tube
★★★★★
★★★★★
4 Reviews
PartSelect Number PS3526625
Manufacturer Part Number 5210JA3005E
This part is the replacement water line or tube for your refrigerator. It is made of white plastic and is sold individually. This tube supplies water to the ice maker and water dispenser If your refrigerator is leaking, or it will not dispense water or ice, you may have a damaged water line. When you replace the water line, you may want to pick up a new water tube union as well. You can use a utility knife to cut the old water line where it is damaged and use the union to attach the new water line to the old one. This tubing is an OEM part from the manufacturer.
Fixes these symptoms
Installation Instructions
Debbie from FISHER, AR
Broken water line
Remove water filter and water filter holder. Removed cover on back of frig. Removed clip where water line connects to back of water filter. Took half inch wrench pushed in on water line lock to release line. Repeat at other end. Reverse steps to put on new line. Easy repair. Read more...

Related Kenmore Refrigerator Parts

Back to Top